Advantech PCM-3780 manual Two Years Product Warranty

Page 3

Two Years Product Warranty

Advantech warrants to you, the original purchaser, that each of its prod- ucts will be free from defects in materials and workmanship for two years from the date of purchase.

This warranty does not apply to any products which have been repaired or altered by persons other than repair personnel authorized by Advantech, or which have been subject to misuse, abuse, accident or improper instal- lation. Advantech assumes no liability under the terms of this warranty as a consequence of such events.

Because of Advantech.s high quality-control standards and rigorous test- ing, most of our customers never need to use our repair service. If an Advantech product is defective, it will be repaired or replaced at no charge during the warranty period. For out-of-warranty repairs, you will be billed according to the cost of replacement materials, service time and freight. Please consult your dealer for more details.

If you think you have a defective product, follow these steps:

1.Collect all the information about the problem encountered. (For exam- ple, CPU speed, Advantech products used, other hardware and software used, etc.) Note anything abnormal and list any onscreen messages you get when the problem occurs.

2.Call your dealer and describe the problem. Please have your manual, product, and any helpful information readily available.

3.If your product is diagnosed as defective, obtain an RMA (return mer- chandize authorization) number from your dealer. This allows us to pro- cess your return more quickly.

4.Carefully pack the defective product, a fully completed Repair and Replacement Order Card and a photocopy proof of purchase date (such as your sales receipt) in a shippable container. A product returned without proof of the purchase date is not eligible for warranty service.

5.Write the RMA number visibly on the outside of the package and ship it prepaid to your dealer.

iii

Image 3
Contents PCM-3780 Ch Counter/Timer with Ch TTL DIO ModuleCopyright Acknowledgements Two Years Product Warranty CE Notification FCC Class a Technical Support and Assistance Packing List Page Contents Appendix Specifications Introduction Features Counter Modes PCM-3780 Counter ModePCM-3780 Counter Mode Applications Installation GuideInstallation Flow Chart Register-level Programming Software OverviewDevice Drivers on the companion CD-ROM Device DriversProgramming Tools Device Drivers Programming RoadmapProgramming with Device Drivers Function Library Troubleshooting Device Drivers ErrorAccessories Wiring CablesWiring Boards Hardware Installation Unpacking Companion CD-ROM Driver InstallationDifferent Options for Driver Setup Installing the Module Hardware InstallationPage Pin Assignments & Jumper Settings Overview Signal ConnectionsInterrupt Level IRQ Setting JP1 Switch and Jumper SettingsBase Address Setting Base Address Setting SW1Connectors Pin Assignment CN3 I/O Port ConnectorCN4 Counter Interface Connector Reference Direction Description Connector Signal DescriptionUsing Advantech 32-bit DLL Driver Using Direct I/OPeriod Measurement Frequency Measurement Frequency MeasurementSpecifications Digital Input/Output Programmable CounterGeneral Page Block Diagram Appendix B Block Diagram Register Structure & Format I/O Port Address Map Appendix C Register Structure & FormatTable C.1 Register Offset Address Table Register FormatCE CE CM6 to CM3 Count Control CM6 Counter 0/1 Mode RegisterCM2 Output Enable Control CM1 to CM0 Output ControlCM15 Gate Active Edge or Level CM7 Count Source EdgeCM13 to CM12 Gate Source Selection CM14 Gating Polarity SelectionCounter 0/1 Hold Register Counter 0/1 Load RegisterCE1 to CE0 Counter Command Enable Bit Counter 0/1 Command RegisterCounter Command Enable Register C2 to C0 Command CodeInterrupt Status Register Interrupt Control RegisterO Direction Control Bit Interrupt Clear RegisterDirection Control Register Port A/B/C Interrupt Status RegisterDV3 to DV0 Fout Divider Divide by 1 to 16 0000 = Divide by Fout RegisterFS2 to FS0 Fout Source FOE Fout Output EnableWaveform of Each Mode Counter Mode Descriptions Appendix D Waveform of Each ModeTable D.1 PCM-3780 Counter Mode Table D.2 PCM-3780 Counter Mode Software-Triggered Strobe with No Hardware Gating Mode a WaveformsSoftware-Triggered Strobe with Level Gating Mode B WaveformsHardware-Triggered Strobe Mode C WaveformsRate Generator with No Hardware Gating Mode D WaveformsRate Generator with Level Gating Mode E WaveformsNon-Retriggerable One-Shot Mode F WaveformsSoftware-Triggered Delayed Pulse One-Shot Mode G WaveformsMode H Waveforms Hardware-Triggered Delayed Pulse Strobe Mode I WaveformsVariable Duty Cycle Rate Generator with No Hardware Gating Mode J WaveformsVariable Duty Cycle Rate Generator with Level Gating Mode K WaveformsHardware-Triggered Delayed Pulse One-Shot Mode L WaveformsHardware-Triggered Strobe with Edge Disarm Mode O WaveformsNon-Retriggerbale One-Shot with Edge Disarm Mode R WaveformsHardware-Triggered Delayed Pulse Strobe with Edge Disarm Mode U WaveformsHardware-Triggered Delayed Pulse One-Shot with Edge Disarm Mode X Waveforms