Polk Audio DP-1 Erasing All the Learned Commands All Device Modes, Restoring Factory Programming

Page 35

PROGRAMMING THE REMOTE

Erasing All the Learned Commands

in All Device Modes

This procedure will erase all the learned commands on all the buttons in all eight Source/Device modes. Be really, really sure you want to do this before following the steps below.

1. Press and hold the LEARN button for two seconds.

The Status light at the top left of the remote will glow orange.

2. Press and hold the LEARN button again for 10 seconds. The Status light will flash red continuously. The status light will then flash green once, orange once then turn off, indicating that all of the learned commands in all of the Source/Device modes on the remote control have been erased.

Restoring Factory Programming

If you want to restore the DR-3 to it’s original programming and oper- ation, press the LIGHT and POWER buttons simultaneously for 10 seconds. The red status light will blink while the remote is resetting. It will confirm the reset by blinking green and then orange.

1,2

www.polkaudio.com

11

Image 35

Contents DP-1 Important Safety Instructions Please read the following carefully PrecautionsWord from Matthew Polk Getting Started Connecting the DP-1Basic Setup Remote Controls These buttons serve two DR-3 Remote Guided TourRemote Controls Push this button once to pause playing How to navigate and select choices DP-1 SET UP MenusMenu Language Options Setting Digital Audio Output Sample FrequencySetting DRC Unlocking the Rating Block Parental Block/Password Menus optionalSetting a Rating Setting a PasswordPlaying a DVD DVD OperationAdvanced DVD Operation Graphic User Interface GUI Menus Advanced CD Operation CD OperationPlaying a CD Functions as shown in the chart figure Playing an MP3 CD MP-3 OperationMP3 Notes Advanced MP3 OperationTroubleshooting Guide Troubleshooting Guide Outputs DP-1 SpecificationsPolk Audio Limited Warranty DVD PlayerPolk Customer Service 800 RM2069-1 DR-3 Programming the Remote IntroductionVOL Stop Page Button Name DR-3 Function ListManual Three-Digit Code Method Programming the RemoteFinding the Three-Digit Code Number for a Device Auto Search MethodTeaching Method To Erase All the Learned Commands One Source/Device Mode Erasing a Learned Command From a ButtonRestoring Factory Programming Erasing All the Learned Commands All Device ModesTo Erase a Macro Sequence Macro OperationProgramming the Macro Button Macro Sequence Programming Example Factory ResetManufacturer/Brand Set-Up Code Number Setup CodesVCR Aiwa Manufacturer/Brand Set-Up Code Cable TV Set-Up CodeManufacturer/Brand Set-Up CodeRM2070-1 Page Page