Connections and Set-up
Unpacking and installing
Warning:This operation requires two people.
1. Place the box upright with its underside on a solid base.The direction of the arrowheads on the long side of the box indicates the top of the box.
2. Remove the packaging tape from the opening edge and open the box’s flap outwards. Remove the two top polystyrene packing corners and take the accessories box out of the
Front panel buttons
If the batteries in the remote control are run down you can use the buttons on the TV set’s front panel, under the light, which have the same functions as the corresponding buttons on the remote control.They can also be used to navigate through the menus with the following functions:
VOLUME 
button
VOLUME +: 
button
button
EN
packing.
PR+: 
button
3. Remove the TV set from the packing and place it on a stable, horizontal surface, capable of supporting the load.
Note: Before installing it, make sure that the TV set is switched off and that the mains cable and signal cable are unplugged.
MENU: access to menus.
vol - | vol + | PR - | PR + | menu |
Before setting up your television set, make sure that the surface you want to put the set on can support its weight (see the list of specifications provided with the booklet).
Don’t place the set on an unstable surface (e.g. moving shelf, very edge of a unit).
Hanging the TV set on the wall
Warning:This operation requires two people.
If you want to hang your TV set on the wall, proceed as follows:
1.Turn the TV set over (so that the screen is facing the floor) and place it on a flat, protected surface.
2.Unscrew the four fixing screws from the table stand and remove the stand.
3.Attach mounting brackets (not provided) to the wall.
4.Position the TV set so that the brackets fit into the holes provided for this purpose at the back of the appliance.
Make sure that the TV set is securely fixed and cannot fall off. Note: Check that the wall can support the TV set’s weight and make sure and use a type of screw that is suitable for the material which the wall is made of. If necessary, contact a qualified fitter.
Holes for brackets
4