Chapter 3: Installing the Switch and Modules
Installing the Switch on a Desktop
To install the switch on a desktop, perform the following procedure:
Note
To install the switch in a rack, refer to “Installing the Switch in an
Equipment Rack” on page 45.
1.Remove all equipment from the package and store the packaging material in a safe place.
2.Turn the switch over and place it on a table.
3.Remove the adhesive backing from the rubber feet.
4.Four rubber feet are provided in the switch shipping container, see Figure 11 on page 40. Attach the feet to the bottom of the switch in the corners as shown in Figure 14.
[Bottom of Switch]
Figure 14. Attaching the Rubber Feet
5.Turn the switch over again and place it on a flat, secure surface (such as a desk or table) leaving ample space around the unit for ventilation.
6.The next step in the installation process is installing the power supply module(s). Go to “Installing Power Supply Module” on page 48 for the installation procedure.
44
