Allied Telesis AT-FAN06, AT-PWR06, AT-DC2552XS manual Installing a SFP+ Direct Attach Cables

Installing a SFP+

Direct Attach

Cables

Stack Installation Guide for AT-2552XS L2 Data Center Switch

7.Refer to Table 9 on page 56 for the recommended fiber optic cable. Insert the cable to the port on the transceiver, as shown in Figure 28, until it snaps in place.

Figure 28. Attaching a Fiber Optic Cable to an SFP+ Transceiver

8.Repeat steps 6 and 7 for the cable installation into the remaining SFP+ transceivers that are installed.

The AT-SP10TW1, AT-SP10TW3 and AT-SP10TW7 10G direct attach cables come in 1m, 3m, and 7m cable lengths respectively. These SFP+ cable modules are ordered and supplied separately from the AT-DC2552XS.

Perform the following procedure to install a SFP+ direct attach cables:

1.Remove the dust plug from a SFP+ slot on the switch. Refer to Figure 29.

Figure 29. Removing the Dust Plug from a SFP+ Slot

59