Yamaha DRX-1 owner manual Laser safety, FCC Information for US customers

Page 3

FCC INFORMATION (for US customers)

1.IMPORTANT NOTICE: DO NOT MODIFY THIS UNIT!

This product, when installed as indicated in the instructions contained in this manual, meets FCC requirements. Modifications not expressly approved by Yamaha may void your authority, granted by the FCC, to use the product.

2.IMPORTANT:When connecting this product to accessories and/or another product use only high quality shielded cables. Cable/s supplied with this product MUST be used. Follow all installation instructions. Failure to follow instructions could void your FCC authorization to use this product in the USA.

3.NOTE:This product has been tested and found to comply with the requirements listed in FCC Regulations, Part 15 for Class “B” digital devices. Compliance with these requirements provides a reasonable level of assurance that your use of this product in a residential environment will not result in harmful interference with other electronic devices.This equipment generates/uses radio frequencies and, if not installed and used according to the instructions found in the users manual, may cause interference harmful to the operation of other electronic devices. Compliance with FCC regulations does not guarantee that interference will not occur in all installations. If this product is found to be the source of interference, which can be determined by turning the product “OFF” and “ON”, please try to eliminate the problem by using one of the following measures:

Relocate either this product or the device that is being affected by the interference.

Utilize power outlets that are on different branch (circuit breaker or fuse) circuits or install AC line filter/s.

In the case of radio or TV interference, relocate/reorient the antenna. If the antenna lead-in is 300 ohm ribbon lead, change the lead-in to coaxial type cable.

If these corrective measures do not produce satisfactory results, please contact the local retailer authorized to distribute this type of product. If you can not locate the appropriate retailer, please contact Yamaha Electronics Corp., 6600 Orangethorpe Ave. Buena Park, CA90622.

The above statements apply ONLY to those products distributed by Yamaha Corporation of America or its subsidiaries.

English

THIS DIGITAL APPARATUS DOES NOT EXCEED THE CLASS B LIMITS FOR RADIO NOISE EMISSIONS FROM DIGITAL APPARATUS AS SET OUT IN THE RADIO INTERFERENCE REGULATIONS OF THE CANADIAN DEPARTMENT OF COMMUNICATIONS.

CET APPAREIL NUMÉRIQUE N'ÉMET PAS DE BRUITS RADIOÉLECTRIQUES DÉPASSANT LES LIMITES APPLICABLES DANS LA RÈGLEMENT SUR LE BROUILLAGE RADIOÉLECTRIQUES ÉDICTÉ PAR LE MINISTÈRE DES COMMUNICATIONS DU CANADA.

NOTE TO CABLE TV SYSTEM INSTALLER:

This reminder is provided to call the Cable TV (CATV) system installer’s attention to Article 820-40 of the NEC (National Electrical Code) that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical.

Laser safety

This unit employs a laser.To prevent possible eye injury, only a qualified service person should remove the cover or attempt to service this device.

USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE.

LASER

 

Type

Semiconductor laser GaAlAs (DVD)

 

Semiconductor laser AlGaAs (CD)

Wavelength

660 nm (DVD)

 

780 nm (CD)

Output Power

20 mW (DVD +RW writing)

(out of objective)

0,8 mW (DVD reading)

 

0,3 mW (CD reading)

Beam divergence

82 degrees (DVD)

 

54 degrees (CD)

 

 

For Customer Use:

Read carefully the information located on the back of your DVD recorder and enter below the Serial No. Retain this information for future reference.

Model No.

Serial No.__________________________

CAUTION

VISIBLE AND INVISIBLE LASER RADIATION.

WHEN OPEN AVOID EXPOSURE TO BEAM.

 

 

(WARNING LOCATION: INSIDE ON LASER

 

COVERSHIELD)

CAUTION

ONLY QUALIFIED SERVICE PERSONNEL

SHOULD REMOVE THE COVER OR

 

 

ATTEMPT TO SERVICE THIS DEVICE.

GENERAL INFORMATION

Image 3
Contents DRX-1 General Information Important safety instructionsFCC Information for US customers Laser safetyRead this before operating your unit Supplied AccessoriesContents DVD Recorder Cleaning discsRemote control IntroductionConnections back of your DVD Recorder InstallationConnecting to the antenna or Cable TV signal Connecting to a TVDigital Multi-channel sound Connecting to audio equipmentVideo Y/C connection Video Cvbs connectionConnecting to a receiver with two channel analog stereo Connecting to other equipment optionalConnecting to a receiver equipped with Dolby Pro Logic Connecting to a TV with a Dolby Pro Logic decoderVideo camera connection Power supplySwitching on Connections Front of your DVD Recorder optionalManual setting First time setup Initial setupAutomatic TV Channel Search Functional overview Front of recorderFunctional Overview Video Cvbs Back of RecorderTrack time in minutes and seconds DisplaySelect TimerREC Mode MonitorLoading discs OperationImportant notes for operation Disc typesDVD-RAM On-screen display informationDiscs unsuitable for recording or playing System menu barUser preference menu operation Temporary feedback iconsUser preference menu icons Disc status icons Status boxTuner info box Disc type icons1015pm Timer info boxThu 09 13 Index Picture ScreenUser preferences Setting user preferencesPicture settings Sound settingsFeature settings Language settingsRemote Control setting Record SettingsPBC VCR Plus+ ch InstallationUpdate/Re-install TV channel Add and delete TV channelsTime/Date Manually Press ENTER/OKCable/Antenna Checking input RecordingBefore you start recording Manual recording of a TV channel or from a video cameraRecording Manual audio controlSafe Recording When using timer recording Timer programmingRecording with automatic switch-off OTR One-Touch Recording Timer programming with the VCR Plus+ systemSystem Timer programming without the VCR Plus+Checking or altering a Timer Recording If a timer recording is incorrectHow to stop a Timer Recording in progress Clearing a timer blockPlaying a Super Video CD PlaybackPlaying a DVD+RW/+R disc Playing a pre-recorded DVD- Video discGeneral features Moving to another title/trackMoving to another chapter/index Slow Motion SearchStill Picture and Frame-by-Frame Playback Time search RepeatRepeat A-B ScanSpecial DVD-Video features Special DVD+RW/+R featuresPlayback Control PBC Special VCD featuresSubtitles Camera AngleRepeat track/disc Playing an Audio CDPause Moving to another trackActivating/deactivating the child lock Access controlAccess Control Child Lock DVD and VCDActivating/Deactivating Parental Control Authorizing discs when Child Lock is activatedParental Level DVD-Video only Locking Discs that were formerly unlockedChanging the 4-digit code CountryManaging disc content DVD+RW/+R only Title settingsDisc Information Screen Erase disc Disc SettingsDisc name ProtectionEditing Make edits DVD-compatibleCalling up the Edit menu Changing the index picture Inserting a chapter markerHiding a chapter Deleting chapter markersAppend recording Troubleshooting TroubleshootingDVD player shows the Index Picture Symptom RemedyIndex Picture Screen does not appear But the titles on the disc still a play periodDiagnosis program DVD Recorder system notesInstructions Term Explanation GlossaryAppendix Using your DVD Recorder remote control with your TVPower B/I AppendixSamsung , 1005, 1009, 1010 1046, 1063, 1064, 1066 Remote control codes for televisionSpecifications SpecificationsYamaha Corporation