16If you make a mistake, go back with t (left cursor) and
17Confirm with ENTER/OK.
➤ When all information is correct, the data is stored in a timer block.
18To end, press TIMER.
19Make sure you inserted a disc without write protec- tion. If you inserted a write protected disc, recording will not occur.
20Turn the Recorder to standby mode by pressing POWER (B/I).
If a timer recording is incorrect
The following messages may appear in the timer menu when you set a timer recording:
Collision
The Timer recording overlaps with another timer recording.
Solution:
●Ignore by pressing TIMER again.The program with the earlier start time will record completely.Then the remainder of the later program will record.
●Edit one or both timer recordings.
●Delete one of the timer recordings.
Please enter channel number
The VCR Plus+ system does not recognize the TV channel. Solution:
●Select the required channel number with t/u (left/ right cursor).
●Press ENTER/OK to confirm.
PlusCode number wrong
You entered an incorrect PlusCode number. Solution:
●Enter the correct information or quit by pressing
TIMER.
Weekend programming - not possible
Date was incorrectly entered. Daily programming can only be used for recordings from Mondays to Fridays.
Memory full
All the timer blocks are in use.
Solution:
●Delete one of the Timer recordings.
Clock not set-check Clock channel
The clock is not set. Set it manually (See ‘Time/Date Manually’) or adjust the Clock channel (See ‘Time/Date Automatic.’)
Data error
Solution:
●Make sure all information is correct and complete.
Checking or altering a Timer Recording
1Press TIMER on the remote control.
2Select ‘Timer list’ with w/v (down/up cursor).
Timer
VCR Plus+ system
Timer programming
Timer list
To exit
Press TIMER
3Press u (right cursor).
Timer
Timer List
|
|
|
|
| Rec |
Date | Ch. | Start | End | Mode | |
04/ | 20 | 120 | 09:00PM | 11:00PM | SP+ |
07/ | 20 | 089 | 08:30PM | 09:30PM | SP+ |
10/ | 20 | 065 | 07:00AM | 07:30AM | SP+ |
11/ | 20 | 120 | 09:00PM | 11:00PM | SP+ |
|
| Total record time 05: 30 |
| ||
To change |
| To exit |
| ||
Press > |
| Press TIMER | |||
4Select the timer recording you want to check or alter with w/v (down/up cursor).
➤ The selected timer recording will be highlighted in blue.
5Press u (right cursor).
6Select what you want to check or alter with t/u (left/ right cursor).
7Alter data with w/v (down/up cursor) or with the digit buttons
8Press ENTER/OK to conform.
9To end, press TIMER, repeatedly if necessary to remove the menus.
10Turn the Recorder to standby mode by pressing POWER (B/I).