Stereo Recording and Playback, Output Selection

STEREO RECORDING AND PLAYBACK

RECORDING STEREO BROADCASTS

The VHS Hi-Fi audio system permits high fidelity recording of MTS STEREO TV broadcasts.

SECOND AUDIO

PROGRAM (SAP)

Your TV/VCR is fitted with an SAP broadcast system which enables you to switch to a SECOND AUDIO PROGRAM when viewing a selected channel.

This function applies only when the program is broadcast in multi-languages through the SAP

When an MTS STEREO broadcast is received, the STEREO will appear on the screen and the program can be viewed or recorded in stereo. The Hi-Fi STEREO recording procedure is the same as for normal record- ings.

STEREO

broadcast system.

CHECK BEFORE YOU BEGIN

•Turn ON the TV and set to the video channel 3 or 4.

•Turn ON the VCR POWER button.

•Press the TV/VCR selector button to select the VCR mode.

When a TV is connected with an audio/video cable, turn the TV on and select the video input mode on the TV.

NOTE: When using a CATV system, stereo TV programs may be transmitted over a mono cable channel. In this case the word “STEREO” will not appear and the sound will be in mono.

OUTPUT SELECTION

When viewing an MTS STEREO TV program, or playing a prerecorded VHS Hi-Fi STEREO videotape, press the SOUND button to allow the audio to be heard through both speakers. Normally set to the Hi-Fi STEREO position, this button can be set to the MONO position if the stereo broadcast or videotape audio is of poor quality. The “R” and “L” positions allow the audio from the Right or Left Hi-Fi channel to be heard over both TV speakers. This button has no effect when viewing a MONO videotape or TV program. Each time you press the button, the OUTPUT SELECTION display appears

1To display the picture adjust- ment screen, press the MENU button. Press the SET + or – button to select the TV SET- UP option, then press the ENTER button.

2Press the MENU button. Press the SET + or – button to select the SAP option.

3Press the ENTER button to select the ON position.

M E N U

TIMER REC SET

TV SET-UP

CH SET-UP

AUTO REPEAT ON OFF SYSTEM SET-UP

〈+/–/ENTER/MENU〉

TV SETUP

V-CHIP SET

ON/OFF TIMER

PICTURE

AUDIO

SAP ON OFF

+/–/ENTER/MENU

TV SET-UP

V-CHIP SET

ON/OFF TIMER

PICTURE

AUDIO

SAP ON OFF

+/–/ENTER/MENU

on the screen for several seconds. Refer to the chart below.

OUTPUT	SOUND HEARD ON BOTH
SELECTION	SPEAKERS

STEREO	STEREO
L CH	LEFT CHANNEL AUDIO
R CH	RIGHT CHANNEL AUDIO
MONO	MONO

NOTES: • When playing back a tape that is not recorded in Hi-Fi stereo mode, the audio will automati- cally be monaural.

•When listening to a VHS Hi-Fi video tape or MTS broadcast through the VHF/UHF jack, the sound will be monaural.

4Press the MENU button again.

LISTENING TO SAP

When the TV/VCR is turned on or a channel selection is made, make certain “SAP” appears on the screen. This means that the “Second Audio Program” broadcasting is available.

STEREO SAP

SAP