Sony NSX-A959 manual Prepare the source

6

1,2, 3,4

2,3,4

----

The unit can be turned on at a specified time every day with the

built-in timer.

Preparation

Make sure the clock is set correctly.

1 Press CLOCIVTIMER twice to display 0, then press 11 SET within 4 seconds,

@is displayed, and the hour flashes.

When using the remote control

Press TIMER, then press [1 SET within 4 seconds.

m

If you press 11 SET after 4 seconds, another operation may start.

2 Designate the hour of the timer-on time by

pressing +-4DOWN or - UP, then press 11 SET. Repeat to designate the minute of the timer-

After you designate the timer-on time, one of the source names

flashes on the display.

3 Press ~ DOWN or P=b UP to select a source, then press II SET.

@If TUNER is selected, the band cannot be selected in this

step,

4 Select the duration for the timer-activated period

E

with -44 DOWN or ~ UP, then press 1I SET. ,;*,

G

The duration for the timer-activated period can be set between 5 and 240 minutes in 5-minute steps.

5 Prepare the source.

To listen to a CD, load the disc to be played first on tray 1. To listen to a tape, insert the tape into deck 1 or 2.

To listen to the radio, tune in to a station.

6 Press POWER to turn the unit off after adjusting the volume and tone.

@remains on the display after the power is turned off (timer standby mode).

When the timer-on time is reached, the unit turns on and begins play with the selected source.

a The volume level is automatically set to 20 when the power is turned off with the volume level set to 21 or more.

To check the specified time and source

Press TIMER once on the remote control. The timer-on time, the ❑

timer-activated period and the selected source name are displayed for 4 seconds.

To cancel timer standby mode temporarily

Press TIMER on the remote control repeatedly until@ or @REC disappears on the display.

To restore the timer standby mode, press TIMER again once or twice to display @ or @REC.

Using the unit while the timer is set

You can use the unit normally after setting the timer.

Before turning off the power, carry out step 5 to prepare the source, and adjust the volume and tone.

*Timer playback and timer recording will not begin unless the power is turned off.

*Connected equipment cannot be turned on and off by the built- in timer of this unit. Use an external timer.

Timer recording is applicable for TUNER and VIDEO/AUX (with an external timer) sources only.

Press TIMER on the remote control repeatedly until ~ REC appears on the display, then press 11 SET within 4 seconds.

Carry out the steps of “SETTING THE TIMER” from step 2 and insert the tape to be recorded into deck 2 after step 5.

‘MULTI JOG is also available instead of U and >. ENTER is also available instead of II SET.

ENGLISH 22