Sony NSX-A959 Sound Adjustment During Recording, Insert the tape to be recorded on into deck

This section explains how to record from the tuner, CD player, or external equipment.

4

3

Preparation

●Set the tape to the point where recording will start.

●Use Type I (normal) and Type II (high/CrOz) tapes for recording.

1Insert the tape to be recorded on into deck 2.

Insert the tape with the side to be recorded on first facing out from the unit.

A EJECT

I4

2 Press REV MODE to select the reverse mode.

To record on one side only, select z.

To record on both sides, select Z) or C=).

3Press DOLBY NR to turn Dolby NR on or off.

To record with DOLBY NR, turn on no NR,

To record without DOLBY NR, turn off DO NR.

4 Press function (CD, TUNER, VIDEO/AUX or MD) and prepare the source to be recorded.

To record from a CD, press CD and load the disc(s).

To record from a radio broadcast, press TUNER and tune

in to a station.

To record from a connected source, press VIDEO/AUX or

MD and play.

5 Press ● RECIREC MUTE to start recording.

To stop recording, press ■ .

To pause recording, press II. (Applicable when the source is TUNER, VI DEO/AUX or MD.) To resume recording, press again.

Insertion of 4-second blank spaces enables you to activate the Music Sensor function. (Applicable when the source is TUNER, VIDEO/AUX or MD.)

1 Press ● REC/REC MUTE during recording or while in recording pause mode.

~on the display flashes for 4 seconds and the tape runs without recording. After 4 seconds, the deck enters the recording pause mode.

2Press II to resume recording.

To insert a blank space of less than 4 seconds, press ●

REC/REC MUTE again while ~ is flashing.

To insert blank spaces of more than 4 seconds, after the deck enters recording pause mode, press ● REC/REC MUTE again. Each time the button is pressed, a 4-second blank space

is added.

-. ~

..+ -,:= .- , :,.1-‘a.w$.*&amT--- r, .- :- .- = .-=+?

SOUND ADJUSTMENT DURING

RECORDING

The output volume and tone (except BBE and Rhythm play function) of the speakers or headphones may be freely varied without affecting the level of the recording.

Recording with BBE

The desired source can be recorded with the BBE function to enhance the clarity of high-frequency sound. When playing back a tape recorded with BBE, it is recommended that BBE be set to off.

To erase a recording

Make sure the micro~hone is not connected to this unit and the Rhythm play function (page 6 ) is canceled.

1Insert the ta~e to be erased into deck 2 and press TAPEI

DECK 1/2 to”display “TP 2.

2Set the tape to the point where the erasure is to be started.

3Set the reverse mode by pressing REV MODE.

4Press ● REC/REC MUTE to start the erasure.

15 ENGLISH