Connections
Antenna connections
If you are using an antenna system, follow these instructions. If you are a cable (CATV) subscriber, skip ahead to page 16 for the proper connections.
Antenna to DVD/VCR connection
The DVD/VCR must be connected “between” the antenna and the TV. First, disconnect the antenna from the TV and connect it to the DVD/VCR. Then connect the DVD/VCR to the TV. Below are 3 common methods of connecting an antenna system to a DVD/VCR. Find the type of antenna system you are using and follow the connection diagram.
1 | Combination VHF/UHF Antenna with 75 ohm Coaxial Cable |
|
|
| |
|
| DVD/VCR |
|
| (AT)IN |
| 75 ohm Coaxial Cable | OUT(TV) |
|
|
2 | Combination VHF/UHF Antenna with 300 ohm Twin Lead (Flat) Wire |
| |
|
| DVD/VCR | |
|
| Matching Transformer 300 ohm Input 75 | (AT)OUT(TV)IN |
|
| ohm output (not supplied) | |
|
| 300 ohm Twin Lead (Flat) Wire |
|
|
| (not supplied) |
|
3 | Separate VHF and UHF Antennas | DVD/VCR | |
| |||
| UHF | Combiner 75/300 ohm Inputs 75 ohm output |
|
| (not supplied) |
| |
| VHF | 300 ohm Twin Lead (Flat) Wire | IN |
|
| ||
|
| (not supplied) | |
|
| (ANT) | |
|
|
| OUT |
|
|
| (TV) |
| 75 ohm Coaxial Cable |
| |
Note: If both VHF and UHF antennas have 300 ohm twin lead (flat) wires, use a combiner having two 300 ohm inputs and one 75 ohm output.
Notes: • A clear picture will not be obtained by the DVD/VCR unless the antenna signal is good. Connect the antenna to the DVD/VCR properly.
•For better quality recording, an indoor antenna or a telescopic antenna is not recommended. The use of an outdoor type
antenna is required.
14 • If you are not sure about the connection, please refer to qualified service personnel.
2C53601A | 14 | 3/10/04, 11:31 |