Toshiba SD-V396SU owner manual Lightning, Heat

Page 4

Introduction

IMPORTANT SAFEGUARDS

13.LIGHTNING

To protect your unit from a lightning storm, or when it is left unattended and unused for long periods of time, unplug it from the wall outlet and disconnect the antenna or cable system. This will prevent damage to the unit due to lightning and power line surges.

14.POWER LINES

An outside antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits, or where it can fall onto or against such power lines or circuits. When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits, as contact with them might be fatal.

15.OVERLOADING

Do not overload wall outlets and extension cords, as this can result in a risk of fire or electric shock.

16.OBJECT AND LIQUID ENTRY

Do not push objects through any openings in this unit, as they may touch dangerous voltage points or short out parts that could result in fire or electric shock. Never spill or spray any type of liquid into the unit.

17.OUTDOOR ANTENNA GROUNDING

If an outside antenna or cable system is connected to the unit, be sure the antenna or cable system is grounded to provide some protection against voltage surges and built-up static charges, Section 810 of the National Electrical Code, ANSI/NFPA 70, provides information with respect to proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors, location of antenna discharge unit, connection to grounding electrodes, and requirements for the grounding electrode.

18.SERVICING

Do not attempt to service this unit yourself as opening or removing covers may expose you to dangerous voltage or other hazards. Refer all servicing to qualified service personnel.

For example:

a.When the power-supply cord or plug is damaged.

b.If liquid has been spilled, or objects have fallen into the unit.

c.If the unit has been exposed to rain or water.

d.If the unit does not operate normally by following the operating instructions. Adjust only those controls that are covered by the operating instructions, as an improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the unit to its normal operation.

e.If the unit has been dropped or the cabinet has been damaged.

f . When the unit exhibits a distinct change in performance, this indicates a need for service.

19.REPLACEMENT PARTS

When replacement parts are required, be sure the service technician uses replacement parts specified by the manufacturer or those that have the same characteristics as the original part.

Unauthorized substitutions may result in fire, electric shock or other hazards.

20.SAFETY CHECK

Upon completion of any service or repairs to this unit, ask the service technician to perform safety checks to determine that the unit is in proper operating condition.

21.HEAT

The product should be situated away from heat sources such as radiators, heat registers, stoves, or other products (including amplifiers) that produce heat.

22.DISC TRAY

Keep your fingers well clear of the disc tray as it is closing. It may cause serious personal injury.

23.CONNECTING

When you connect the product to other equipment, turn off the power and unplug all of the equipment from the wall outlet. Failure to do so may cause an electric shock and serious personal injury. Read the owner's manual of the other equipment carefully and follow the instructions when making any connections.

4

2C53601A (E)p02-13

4

3/10/04, 11:30

Image 4
Contents SD-V396SU Introduction Location of the required MarkingS3125A IntroductionLightning HeatNEC Section DiscS2898A Precautions Do not use the DVD/VCR when moisture condensation may occurTo obtain a clear picture WaitOn cleaning discs On handling discs Structure of disc contentsOn storing discs Playable discs On Video CDsDVD Contents Front panel Identification of controlsRear panel Display window VCR operation statusDVD/CD/VCD operation status While watching TVRemote control SkipBattery precautions OperationAntenna connections Antenna to DVD/VCR connectionConnections Combination VHF/UHF Antenna with 75 ohm Coaxial CableSet the TV/CATV menu option to TV mode DVD/VCR to TV connectionConnections TV with 300 ohm UHF and 75 ohm VHF Antenna inputsCatv Cable TV connections Splitter Incoming Cable Splitter Converter/DescramblerConnecting to a TV Connecting to a TVTo wall outlet Component videoConnecting to optional equipment Connecting to an amplifier equipped with a DTS decoderMPEG2 sound Setting the video channel Setting the video channelBasic setup When a TV is connected with the 75 ohm coaxial cable onlySetting the language Setting the languagePreparation Press VCR MenuClock setting Auto Clock adjustmentTo set Auto Clock to off Function properly if the reception condition is not goodOFF To set Standard TimeAuto Manual clock setting Press VCR MENU.VCR MenuPress SET + or to set the month, then press EnterTuner setting Press Enter to select the TV or Catv modeTV/CATV selection TV VHF/UHF channels Catv Cable TV channelsTo ADD/DELETE channels Noise eliminationLoading and unloading a cassette tape LoadingUnloading To prevent accidental erasurePlayback Cassette tape playbackRewind or forward the tape Special playback Convenience function Repeat playback Zero return functionClock/counter display Video index search system Sqpb S-VHS Quasi PlaybackCounter ClockRecording a TV program Recording a TV programRecording VCR VHF/UHF/CATV Channels CatvTo stop recording temporarily To stop recordingRecording one program while watching another One-touch Timer Recording OTR One-touch Timer Recording OTRTo cancel OTR Set TV or Catv option to the appropriate positionTimer recording Timer recordingThrough VCR Menu To return to the normal screen To confirm or cancel a program To cancel Timer programIf the programs overlap another Press VCR Menu repeatedly until the menuStereo recording and playback Second Audio Program SAP Other functions VCROutput selection Listening to SAPDuplicating a video tape Duplicating a video tapeConnection with second VCR Connection with CamcorderRecording a DVD/CD disc Duplicating a DVD or CD discPress Play to start playback Press REC/OTR to start recordingTo start playback in the stop mode Playing a discBasic playback Basic playback DVDTo pause playback still mode To obtain a higher quality pictureAbout To stop playbackVCD Playing in fast reverse or fast forward directions Vcddvd Playing frame by frameVcddvd Playing in slow-motion VCD Locating a chapter or trackMP3/WMA/JPEG playback CD MP3/WMA playbackAdvanced playback DVD MP3/WMA/JPEG CD InformationJpeg CD playback PressPress Stop to end playback File menu appears on the TVSetting the Jpeg Interval Setting the Select Files Zooming Jpeg CD Changing angles Jpeg CDCancel Zooming/Locating desired sceneVcddvd Zooming Locating desired sceneMarking the scenes Marking desired scenesVCD Returning to the scenes VCD A-B Repeat playback Repeat playback/A-B Repeat playbackCD/VCD To cancel program playback Program playback/Random playback CDProgram playback VCD Random playbackChanging angles/Title selection/DVD menu Changing anglesTitle selection DVD menuSetting surround sound Function setup DVDDVD Changing soundtrack language During disc playback press AudioSetting subtitles/Karaoke playback Turning the subtitles on and offChanging the subtitle language Karaoke playbackSetting E.B.L L. Enhanced Black LevelPress or ENTER, then press or to select E.B.L Press / or Enter to select On or OffSetting the aspect ratio of TV screen Setting the aspect ratio of TV screenSetting on screen display/Status display of disc Setting on screen displayVcdcd Status display of disc Video CDPress Setup in the stop mode Press or to select Sound Press or ENTER, then press or to select Desired settingDynamic Range Control Dynamic Range ControlParental control setting Parental control settingTo change the parental level If you forget the passwordTo change the parental level Playback will commence if the entered Password was correct Temporary disabling of rating level by DVD discLoad a DVD disc and press Play or OPEN/ Close on the unit ReturnSetting OSD language VCD Setting OSD languageSetup language can be selected Press or Enter to select OSD LanguageSetting language Setting languageSelecting Progressive scan VCD Selecting Progressive scanLanguage code list OthersTroubleshooting Symptoms Possible Solutions DVD/VCRSpecifications Supplied accessoriesGeneral Input/OutputLimited warranty Others 04/04 U Referencìa rápida PrecaucionInstrucciones Importantes Ajuste del canal de video Conexión a un televisorSeleccion de idioma en pantalla Ajuste de reloj automatico Ajuste de reroj manualSeleccion de TV/CATV Ajuste automático de los canalesReproducción Camara lentaAvance cuadro a cuadro Rebobinado o avance rápido de la cintaSeleccione la opción Timer REC SET y presione Enter Para cancelar OTRGrabacion por temporizador Presione SET + o para seleccionar el N deReproducción básica DVD Reproducción con avance rápidoReproducción con retroceso rápido Reproducción FijaBúsqueda de un capítulo o canción Funciones básicas del control remotoColoque las pilas Notas sobre los derechos de autor