Rear Panel

INTRODUCTION

PREPARATION

OPTION BOX cover	4	5	6
		ALL CLEAR
			IN

GND	ALARM
RESET

OUT
GND	.
GND	EXT CONT
IN

GND	.
GND	REC TRIGG
OUT

TAPE END

SEE MANUAL

10 BATTERY cover

REMOTE IN

MIC IN

IN VIDEO OUT

AUDIO

SEE MANUAL

8 11 12

RECORDING	OPERATION

PLAYBACK	OPERATION

NOTICE

1TAPE END OUT terminal

Signal output terminal to annunciate to other devices that the tape has run out on the VCR.

2REC TRIGGER OUT terminal

Signal output terminal to control the switching interval of the video cameras when connected to a sequential switcher or multiplexer.

3ALARM OUT terminal

Output terminal to transmit an alarm signal to peripheral equipment.

4ALARM RESET terminal

Input terminal to reset alarm recording.

Alarm recording is reset when this terminal is connected to the ground terminal during recording.

5ALARM IN terminal

Input terminal to start alarm recording.

The VCR goes into alarm recording mode when this terminal is connected to the ground terminal while in the record mode, record pause mode, or stop mode.

6ALL CLEAR button

Pressing this button will clear the entire time-date, and timer program memory. The power will be turned off at the same time. Pressing the POWER button will restore power.

7REMOTE IN jack

Input jack for optional wired remote control.

8MIC IN jack

Input jack for audio signals from a microphone. The RCA jack input (audio input) is automatically switched off when this jack is utilized.

9VIDEO IN connector (BNC)

Input connector for video signal. Connect with an external video source such as a video camera, etc.

pVIDEO OUT connector (BNC)

Output connector for video signal. Connect with a monitor TV.

qAUDIO IN jack (RCA type)

Input jack for audio signal. Connect with an external audio source.

wAUDIO OUT jack (RCA type)

Output jack for audio signal. Connect with an external audio equipment.

eEXTERNAL CONTROL IN terminal

Automatic recording is performed when this terminal is connected to the signal ground while in the timer mode (timer recording or timer standby).

Notes:

•ALL CLEAR button

Do not use this function (ALL CLEAR) frequently. Press this button only when an abnormality (ex. VCR display does not turn ON.) occurs.

When this button is pressed, the power turns OFF and each data stored (ex. clock, timer program, etc.) is cleared and returns to the initial setting status. It will be necessary to re-program the VCR after turning the unit on again.

•OPTION BOX cover

This VCR provides an optional port for connecting an optional module to the rear of the unit.

If you would like additional information regarding the available options for this VCR please consult your dealer. The installation of the optional module should be per- formed only by qualified technical personnel.