Toshiba SD-W1111 specifications Mounting

Page 15

OD-A017-02

TOSHIBA DVD-RAM SD-W1111

‘99/06/26 Version 1.0

10. Mounting

10.1 Mounting

Mount the drive using four M3 tapping holes bottom and two M3 tapping holes on each side. The following shows an example mounting on a personal computer or a sub system.

Flatness deviation under 0.5mm

Use screws of which length inside the drive should be more than 2.5mm and less than 3.5 mmfrom the drive frame surface.

Keep this gap less than 0.5mm .

Before fixing

After fixing

Page 15

Product Specification

Image 15

Contents Toshiba Toshiba DVD-RAM SD-W1111 Precaution 10.1 15.1 Scope FeaturesExternal views and dimensions DVD-ROM Basic specifications∙ Average seek time Operating time of Seek command Mechanical specifications Power supply specificationsTemperature Reliability specificationsEnvironmental specifications Error rateStatic electricity Relative humidityVibration5 to 300 Hz AltitudeEN61000-4-6 EN61000-4-8 EN61000-4-11 9Blockdiagram Mounting MountingMounting direction Toshiba DVD-RAM SD-W1111 M3 screw Drive Frame 3.5mm Front bezel Standard BezelLED lighting Disc is not loaded, all LED’s turn off Power supply connector Rear View and ConnectorsPin No. table of connector terminal 12.2 I/F connector Scsi connectorExternal view diagram Signal interface Verify setting Mode select headers functionsScsi ID setting Parity check settingAudio Connector Termination settingChange of setting Host interface specification Scsi command setApplicable standard Read Write Disappearance of data in buffer in a write cache operation Error report in a write cache operationAutomatic sector replacement at a write operation Error generation in Read Modify Write operationToshiba DVD-RAM SD-W1111 Bare disc setting at vertical installation AccessoriesToshiba DVD-RAM SD-W1111 Toshiba DVD-RAM SD-W1111 Disc eject at emergency Deviation List Rev # 0.9aRev #