| |
TOSHIBA | ‘99/06/26 Version 1.0 |
15. MISCELLANEOUS
15.1 Accessories
Function setting jumper pins | 5 pieces. |
Emergency eject tool | 1 piece. |
15.2 A bare disc setting at vertical installation
In case of using a bare disc (ex.
1.Draw three disc holders among the four holders on the tray, two pieces are both holders in down side, one piece is on a rear part in upper side while made to vertical posture as follows.
(Note) Please use 3 pieces holders because the set of the disc becomes difficult when four disc holders are drawn out.
2.Drawing out a disc holder (pull return) can be easily done with inserting a propelling pencil ahead in the hole that is installed on the disc holder.
Page 30 | Product Specification |