Toshiba SD-W1111 specifications Precaution

Page 3

OD-A017-02

TOSHIBA DVD-RAM SD-W1111

‘99/06/26 Version 1.0

Precaution

This equipment (an optical disc drive) handled under the conditions out of product specifications may cause injury, heat generation, trouble, erroneous operation and performance degradation, so, care will be necessary, and proper handling according to the precautions shown below will be required. In case of mishandling without keeping the cautions, safety, reliability and performance of the product are not guaranteed. For systems using this equipment, please note it above mentioned on manuals etc. to understand the users completely.

Cautions

(1)Don’t loosen screws except persons trained with specified instructions. The reliability, safety and performance specified in this specification can not be satisfied.

(2)Don’t modify this equipment. The reliability, safety and performance specified in this specification can not be satisfied.

(3)Don’t insert any objects or cartridge other than specified from the cartridge insertion slot. It may cause trouble or erroneous operation.

(4)Don’t give excessive vibration and shock this equipment. It may cause trouble or erroneous operation.

(5)Toshiba Corporation makes no warranty of any kind, either expressed or implied, including, but not limited to, the implied warranties of merchantability and fitness for a particular purpose. This product may sustain damages which may cause errors and failures. The causes are not confined to what are mentioned or implied in this document. Therefore, the possibilities of error and failure should be taken into consideration when furnishing systems should be protected by such means as system backup and mirroring disk subsystem, especially when this product is used for systems as medical appliances. Toshiba Corporation shall not be liable for incidental or consequential losses or damages to tangible property, injury or death of person in connection with the errors and failures which may occur when furnishing, operating or using this product

(6)When a disc cannot be ejected because of some troubles, etc., turn off the power for this equipment and eject the disc using the emergency eject mechanism after passing more than 1 minute. When the emergency eject is carried out while the power is on or immediately after the power off, the disc may be ejected in a rotating status. Toshiba Corporation does not assure if the disc is damaged by this.

Page 3

Product Specification

Image 3
Contents Toshiba Toshiba DVD-RAM SD-W1111 Precaution 10.1 15.1 Scope FeaturesExternal views and dimensions DVD-ROM Basic specifications∙ Average seek time Operating time of Seek command Mechanical specifications Power supply specificationsTemperature Reliability specificationsEnvironmental specifications Error rateStatic electricity Relative humidityVibration5 to 300 Hz AltitudeEN61000-4-6 EN61000-4-8 EN61000-4-11 9Blockdiagram Mounting MountingMounting direction Toshiba DVD-RAM SD-W1111 M3 screw Drive Frame 3.5mm Front bezel Standard BezelLED lighting Disc is not loaded, all LED’s turn off Power supply connector Rear View and ConnectorsPin No. table of connector terminal 12.2 I/F connector Scsi connectorExternal view diagram Signal interface Verify setting Mode select headers functionsScsi ID setting Parity check settingAudio Connector Termination settingChange of setting Host interface specification Scsi command setApplicable standard Read Write Disappearance of data in buffer in a write cache operation Error report in a write cache operationAutomatic sector replacement at a write operation Error generation in Read Modify Write operationToshiba DVD-RAM SD-W1111 Bare disc setting at vertical installation AccessoriesToshiba DVD-RAM SD-W1111 Toshiba DVD-RAM SD-W1111 Disc eject at emergency Deviation List Rev # 0.9aRev #