Toshiba 42LX196 manual Using the remote control to operate your other devices, Device code setup

Chapter 2: Using the remote control

Using the remote control to operate your other devices

Your TV remote control has one dedicated TV mode and five programmable multi-brand modes: CABLE/SAT, DVD, VCR/PVR, AUX 1, and AUX 2. The default device modes and programmable device modes are listed below.

Note: The TV remote control is preprogrammed to operate most Toshiba devices. To operate a non-Toshiba device or a Toshiba device that the remote control is not preprogrammed to operate, you will need to program the remote control. See “Programming the remote control to operate your other devices” (at right).

MODE SELECT Default device mode control (before programming)

TV	Toshiba TV
CABLE/SAT	Toshiba DST 3100 Satellite receiver
DVD	Orion DVD
VCR/PVR	Toshiba VCR
AUX 1	Yamaha Audio receiver
AUX 2	Onkyo Audio receiver

MODE SELECT Device mode control after programming

TV	Toshiba TV
CABLE/SAT
DVD
VCR/PVR	Multi-brand video/audio devices
AUX 1
AUX 2

Note: Although your new TV’s remote control includes codes for many devices, it may not include codes for some or all of the features on certain devices you wish to control. If you are unable to program the TV’s remote control to operate your device or some of the features on that device, use the device’s original remote control (or the control buttons on the device).

Programming the remote control to operate your other devices

Device code setup

1 Find the code for your device brand in the remote control device code table on pages 17–20.

If more than one code is listed, try each one separately until you find one that works.

2 Press the applicable MODE SELECT button (CABLE/ SAT, DVD, VCR/PVR, AUX 1, or AUX 2), until the MODE SELECT button blinks 3 times.

3 While holding down E, press the Number buttons to enter the category code (0, 1, 2, 3, 4, or 5, as described below) plus the four-digit device code for your device.

Category	Category code
TVs (Toshiba)	0
Cable boxes
Satellite receivers	1
Cable/PVR combos
DBS/PVR combos (1)
DVDs	2
VCRs
PVRs	3
DBS/PVR combos (2)
Audio Amps	4
Audio Amps/Tuners
CD players	5

•If a valid code is entered, the MODE SELECT button will blink twice.

•If an invalid code is entered, the MODE SELECT button will blink one long blink.

4 Point the remote control at the device and press pto test the code.

•If the device responds to the remote control, you have entered the correct code.

•If the device does not respond to the remote control, repeat steps 3 and 4 using another code.

Note: After programming the remote control, make sure all necessary keys on the TV remote control (in addition to p) operate your device. If some keys are not operational, repeat the device code setup using another code (if other codes are listed for your device). If, after trying all listed codes, the necessary keys do not operate your device, use the device’s original remote control.

(continued)

15