Toshiba 42LX196 Setting the time and date, Setting the Hdmi audio mode, To set the time and date

Chapter 4: Setting up your TV

Setting the time and date

Note: If you already set up the TV Guide On Screen™ system, the time and date were set automatically and you can skip this step.

To set the time and date:

1 Press Yand open the Setup menu.

2 Highlight Installation and press T.

3 (A new set of Installation menu icons will appear, as shown below.) Open the Time And Date menu, highlight Start Setup, and press T.

Time And Date

Start Setup

Navigate ENTER Select CH RTN Back EXIT Exit

If you have not set up the TV Guide On Screen™ system, the following screen will appear. To set the time, highlight TV Guide On Screen™ and press T. The TV Guide On Screen™ setup sequence will start, and the time and date will be set automatically.

Time And Date

Your TV Guide On Screen system can provide accurate

time and date information.

It is recommended you set up TV Guide On Screen

first and use it to obtain the time and date.

Manual TV Guide On Screen Cancel

If you have already set up the TV Guide On Screen™ system, or if you have not set up the time, the Time and Date setting screen will appear and you will need to manually set the time and date.

Time And Date
Date (MM/DD/YY)
	0	6	/	3	0	/	0	5
Time (HH:MM)	1	1	:	1	1		AM

In the event that your TV Guide On Screen system has acquired time, the television will use network acquired time rather than manually enterred time.

Cancel Done

Note:

•If you highlight TV Guide On Screen™ (above) to set the time and date through the TV Guide On Screen™ system and a power outage occurs, the time and date will be updated automatically when the power is restored.

•If you highlight Manual (above) to set the time and date manually and a power outage occurs, you will lose the time and date settings when the power is restored.

•If you manually set the time and date and then perform TV Guide On Screen™ setup, the manual time and date settings will be overridden by the TV Guide On Screen™ settings.

Setting the HDMI™ audio mode

To set the HDMI audio mode:

1 Press Yand open the Setup menu.

2 Highlight HDMI 1 Audio and press c.

3 Press b or B to select the HDMI audio mode (Auto, Digital, or Analog) and press T. (Auto is the recommended mode.) See “Connecting an HDMI or DVI device to the HDMI input” (- Installation Guide).

Setup

InstallationAuto

Sleep Timer				Digital
On/Off Timer				Analog
PC Settings
PC Audio			No
HDMI 1 Audio			Auto
Slide Show Interval		2 Sec
Navigate ENTER	Select CH RTN Back EXIT Exit

Note: Because the PC IN and HDMI (DVI) IN inputs share the same set of analog audio inputs, the PC Audio menu setting influences the HDMI 1 Audio menu setting. If PC Audio is set to “No,” the HDMI 1 Audio setting changes to “Auto.” If PC Audio is set to “Yes,” the HDMI Audio setting is set to “Digital” and is grayed out in the menu. (Also see item 2 on page 8 and “Setting the PC Audio mode” on page 51.)

27