Toshiba 65HX83, 57HX83, 51HX83, 46HX83 owner manual Care, Service

Page 4

24)Always operate this equipment from a 120 VAC, 60 Hz power source only.

25)Always make sure the antenna system is properly grounded to provide adequate protection against voltage surges and built-up static charges (see Section 810 of the National Electric Code).

30) [This item applies to projection TVs only.] If the air

temperature rises suddenly (for example, when the TV is

first delivered), condensation may form on the lenses. This

can make the picture appear distorted or the color appear

faded. If this happens, turn off the TV for 6 to 7 hours to

allow the condensation to evaporate.

31) For added protection of your TV from lightning and power

surges, always unplug the power cord and disconnect the

antenna from the TV if you leave the TV unattended or

unused for long periods of time.

Ground clamp

Electric service equipment

Ground clamps

Antenna lead-in wire

Antenna discharge unit (NEC Section 810-20)

Grounding conductors (NEC Section 810-21)

Power service grounding

electrode system (NEC Art 250 Part H)

32) During normal use, the TV may make

occasional snapping or popping

sounds. This is normal, especially

when the unit is being turned on or

off. If these sounds become frequent

or continuous, unplug the power cord

and contact a Toshiba Authorized Service Center.

33) Possible Adverse Effects on TV Picture Tube: If a fixed

(non-moving) pattern remains on the TV screen for long

periods of time, the image can become permanently

26)DANGER: RISK OF SERIOUS PERSONAL

INJURY OR DEATH!

¥ Use extreme care to make sure you are never in a position where your body (or any item you are in contact with, such as a ladder or screwdriver) can accidentally touch overhead power lines. Never locate the antenna near overhead power lines or other electrical circuits.

¥Never attempt to install any of the following during lightning activity:

a) an antenna system; or b) cables, wires, or any home theater component connected to an antenna or phone system.

Care

For better performance and safer operation of your TOSHIBA

engrained in the picture tube and cause subtle but

permanent ghost images. This type of damage is NOT

COVERED BY YOUR WARRANTY. Never leave your TV

on for long periods of time while it is displaying the

following formats or images:

¥ Fixed Images, such as PIP/POP windows, stock tickers,

video game patterns, TV station logos, and websites.

¥ Special Formats that do not use the entire screen. For

example, viewing letterbox style (16:9) media on a

normal (4:3) display (gray bars at top and bottom of

screen); or viewing normal style (4:3) media on a

widescreen (16:9) display (gray bars on left and right

sides of screen).

Service

TV, follow these recommendations and precautions:

27) Always sit approximately 10–25 feet away from the TV and

as directly in front of it as possible. The picture can appear

dull if you sit too far to the left or right of the TV, or if

sunlight or room lights reflect on the screen. Turn the TV

off to check for reflections on the screen, and then remove

the source of reflections while viewing the TV.

34)WARNING: RISK OF ELECTRIC

SHOCK! Never attempt to service the TV yourself. Opening and

removing the covers may expose you to dangerous voltage or other hazards. Refer all servicing to a Toshiba Authorized Service Center.

QUALIFIED

SERVICE

TECHNICIAN

28) Always unplug the TV before

 

cleaning. Never use liquid or

 

aerosol cleaners.

 

 

29)

WARNING: RISK OF ELECTRIC SHOCK!

 

Never spill liquids or push objects of any kind

into the TV cabinet slots.

35)If you have the TV serviced:

¥Ask the service technician to use only replacement parts specified by the manufacturer.

¥Upon completion of service, ask the service technician to perform routine safety checks to determine that the TV is in safe operating condition.

36)When the TV reaches the end of its useful life, ask a qualified service technician to properly dispose of the TV. Improper disposal may result in a picture tube implosion and possible personal injury.

40303

Page 3 Page 5
Image 4
Page 3 Page 5
Contents Appendix IndexSafety Precautions Dear CustomerImportant Safety Instructions InstallationService CareImportant Safety Precautions for Split Cabinet Feature Important Safety Information Introduction Introduction Connecting YourTV Usingthe RemoteControl Settingup YourTV TheTVÕs FeaturesUsing Welcome to ToshibaConnecting a VCR Connecting your TVConnecting a cable converter box Connecting a cable converter box and VCRFrom Setting your Connecting a DVD player with component video and a VCRUsingtheTVÕs Features DTV Antenna Connecting two VCRs Connecting a camcorderConnecting yourTV IntroductionConnecting a device to the DVI/HDCP input Antenna Or CableUsingtheTV’s Features Connecting an audio system Connecting an A/V receiverPreparing the remote control for use Installing the remote control batteriesUsing the Remote Control Remote Control functional key chartCBL/SAT Audio VCR TV/VCR TV/SAT Device code setup Searching and sampling the code of a deviceUsing the volume lock feature Operational feature resetUsingthe RemoteControl Setting up your TV Features Appendix IndexMulti-brand remote control device codes VCRsCD players Learning about the remote control Settingup yourTV Learning about the menu systemUsing the Quick Connect Guide Changing the on-screen display language Connecting Your ControlSelecting the antenna input Adding channels to the TVÕs memory Programming channels automaticallyTo program channels automatically Press z to select CH ProgramIntroduction Connecting YourTV Adding and erasing channels manuallyPress x or to enter the TheaterLink setup mode VCRUsingthe RemoteControl Accessing the TheaterLink on-screen IR device control barTo end, select END TheaterLink IR device codes AmplifiersVideo Accessory Hdtv Decoder Receivers STS Changing channels using SpeedSurf Adjusting the color convergenceChanging channels Manually adjusting the color convergence NumberAdjusting the channel settings Switching between two channels using Channel ReturnSwitching between two channels using SurfLockª Programming your favorite channelsUsing the TVÕs Features Labeling channels Viewing the widescreen picture formats Selecting the picture sizePress z to highlight Press x or to erase the channel labelIntroduction ¥ To raise the picture, press y Press x or to display the Scroll Adjustment mode¥ To lower the picture, press z Using the Auto Aspect feature 480i signals only Selecting the cinema modeUsing the TV’s Features Using the POP double-window featureButtons 0-9 Switching the main and POP pictures Connecting YourTV Usingthe RemoteControlAdjusting the size of the double-window Settingup YourTV UsingtheTV’s Features Appendix IndexUsing the programmed channel search function POP double-window aspect ratioAbout the auto favorite feature Using the favorite channel search functionSetting Your UsingtheTVÕs Features Appendix Index Using the Locks menu Press y or z to display the PIN code entering modeEntering the PIN code If you cannot remember your PIN codeUsing the V-CHIP menu Usingthe RemoteSettingup YourTV UsingtheTVÕs Features Appendix Index TV Rating Independent rating system for broadcastersMpaa Rating Independent rating system for movies Press x or to return to the Locks menuLocking channels Unlocking programs temporarilyTo select each item Press z or y Repeat steps 3 and 4 for other channelsLocking video inputs Press y or z to highlight Clear ALL, and then press x orUsing the game timer Using the front panel lock featureIntroduction Connecting YourTV Control Changing the PIN codeSelecting the picture mode Adjusting the pictureAdjusting the picture quality Introduction Connecting YourTV Usingthe Control Using the ALS ambient light sensor featureSettingup YourTV UsingtheTVÕs Features Using the flesh tone featureSelecting the Scan Velocity Modulation SVM To turn off CableClear DNRSelecting the color temperature Resetting your picture adjustmentsUsing Remote Settingup YourTV UsingtheTVÕs Features Selecting the display format for 480p signals onlySelecting the video input source Labeling the video input sourcesUsing the closed caption feature ¥ To view text, highlight T1, T2, T3, or T4Setting the on timer Setting the sleep timerTo set the clock Press y or z to highlight Clock SETPress Enter to start the clock To display the time on-screenMuting the sound Adjusting the soundSelecting stereo/SAP broadcasts Using the WOWª surround sound feature Adjusting the sound qualityUsingthe RemoteControl Settingup YourTV TVÕs Usingthe FeaturesUsing the sub-bass system SBS Resetting your audio adjustmentsTo turn off the SBS Highlight OFF in above Selecting the Audio OUT sound Turning off the built-in speakersTo turn on the built-in speakers Highlight on in above Using the StableSound¨ feature To turn off the StableSound feature Highlight OFF in aboveSelecting the background of the menu display Displaying on-screen informationUnderstanding the auto power off feature Viewing the demo modeUnderstanding the last mode memory feature Specifications AppendixTroubleshooting Limited United States Warranty Limited Canada Warranty Page Page Page Index Manufactured by
Top Page Image Contents