Satellite 1400 Series Disassembly Overview, cont.
To remove the modem daughter card (MDC), follow the steps below.
1. Turn the computer upside down.
2. Remove one M2.5x4 black flat-head screw.
3. Lift off the modem slot cover.
4. Remove two M2x4 super flat screws securing the MDC.
5. Carefully lift up the MDC to disconnect it from PJ9 (S1400) or PJ125 (S2400) on the system board.
6. Carefully disconnect the modem cable from JP1 on the MDC.
To remove the wireless LAN card, follow the steps below.
1. Remove one M2.5x4 black flat-head screw.
2. Lift off the Wireless LAN card slot cover.
3. Disconnect the Wireless LAN antenna cables (black and white) from the Wireless LAN card using an antenna coaxial cable disconnector.
4. Push the Wireless LAN card lock latches outward to release the card. It will pop up to about a 45 degree angle.
5. Pull out the Wireless LAN card. Be careful not to damage the connector.
To install the wireless LAN card (an option in some models), follow the steps below.
CAUTION: Be sure to turn the computer off before removing the card. Otherwise, the computer or the card may be damaged.
1. Insert the Wireless LAN card into the connector at an angle of 45 degrees.
2. Gently push the Wireless LAN card down until latches on both sides engage to hold it in place.
3. Connect the Wireless LAN antenna (black and white) cables to the connectors on the card.
CAUTION: Be sure the cables lie inside the guide. Be careful not to damage or pinch the cables when you seat the card.
4. Seat the Wireless LAN card slot cover.
5. Secure the cover with one M2.5x4 black
CAUTION: There are two MAC address barcode labels in the package with the card. Apply one labelo next to the Wireless LAN socket and one on the box the computer was shipped in. Remove old labels before applying the new ones. The computer may have MAC address barcod labels both wired and Wireless LANs. Be sure to replace the correct label.
Toshiba TRR | Page 9 | 7/02, Satellite |