Troubleshooting
If you experience any of the following difficulties while using the player, use this troubleshooting guide to help you remedy the problem. Should any problem persist, consult your nearest Sony dealer.
There is no sound.
,Check that the player is connected securely.
,Make sure you operate the amplifier correctly.
,When you use the headphones, adjust the volume with PHONES LEVEL.
There is no sound from the DIGITAL (CD) OUT connectors.
,The audio signals of the super audio CD cannot be output from the DIGITAL (CD) OUT connectors.
The disc does not play.
,There is no disc inside the player.
,The disc is placed upside down on the tray.
,Place the disc on the disc tray with the label side up.
,The disc is placed at an angle. Reload the disc.
,Clean the disc (see page 26).
,Moisture has condensed inside the player. Remove the disc and leave the player turned on for about an hour.
,There is an incompatible disc on the tray (see page 13).
The remote does not function.
,Remove any obstacles in the path of the remote and the player.
,Point the remote at the remote sensor on the player.
,If the batteries in the remote are weak, replace with new ones.
There is no sound from the SUB WOOFER jack.
,Select the playback mode so that the Sub woofer is set to “a” (page 22).
,When you play a track that does not contain the LFE signal, the signal outputs from the SUB WOOFER jack only when you select “5 – Small + SW” or “FRT – Large + SW” for the
Specifications
When a super audio CD is played
Playing frequency range | 2 Hz to 100 kHz |
Frequency response | 2 Hz to 50 kHz |
Dynamic range | 104 dB or more |
Total harmonic distortion rate | |
| 0.0018 % or less |
Wow and flutter | Value of measurable limit (±0.001 % |
| W. PEAK) or less |
When a CD is played
Frequency response | 2 Hz to 20 kHz |
Dynamic range | 99 dB or more |
Total harmonic distortion rate | |
| 0.002 % or less |
Wow and flutter | Value of measurable limit (±0.001 % |
| W. PEAK) or less |
Output connector
| Jack type | Output level |
| Load impedance | |
|
|
|
| ||
ANALOG OUT Phono | 2 Vrms |
| Over 10 kilohms | ||
| jacks | (at 50 kilohms) |
|
| |
|
|
|
|
|
|
DIGITAL (CD) | Square | ( | Light emitting | ) | |
OUT | optical |
| wave length: | ||
OPTICAL* | output |
| 660 nm | ||
| connector |
|
|
|
|
|
|
|
|
|
|
DIGITAL (CD) | Coaxial | 0.5 |
| 75 ohms |
|
OUT | output |
|
|
|
|
COAXIAL* | connector |
|
|
|
|
|
|
|
|
|
|
PHONES | Stereo | 10 mW |
| 32 ohms |
|
| phone jack |
|
|
|
|
|
|
|
| ||
*Output only the audio signals of the CD |
|
|
| ||
General |
|
|
|
|
|
Laser |
| Semiconductor laser |
| ||
|
| (SACD: λ = 650 nm) |
| ||
|
| (CD: λ = 780 nm) |
|
| |
|
| Emission duration: continuous |
| ||
Laser radiant power: | 5.47 uW at 650 nm |
| |||
*These output is the value measured at a distance of about 200mm from the objective lens surface on the optical
Power requirements | 230 V AC, 50/60 Hz |
Power consumption | 25 W |
Dimensions (w/h/d) | 430 × 111 × 283 mm incl. projecting |
| parts |
Mass (approx.) | 5.8 kg |
Supplied accessories
See page 4.
Design and specifications are subject to change without notice.
Additional Information