Clarion MAX675VDII owner manual Basic Operations

Page 30

DVD Video Player Operations

English Owner’s manual

The relationship between DVD video category codes and parental level are shown in the table below. Use this table when setting the parental level.

LEVEL7

NC-17

 

(NO ONE 17 AND UNDER

 

ADMITTED)

 

 

LEVEL6

R

 

(RESTRICTED)

 

 

LEVEL4

PG-13

 

(PARENTS STRONGLY

 

CAUTIONED)

 

 

LEVEL3

PG

 

(PARENTAL GUIDANCE

 

SUGGESTED)

 

 

LEVEL1

G

 

(GENERAL AUDIENCES)

 

 

The contents that the parental level restricts vary with the country code.

WARNING

Some videos may be recorded at higher than desired volume levels. Increase the volume gradually from the minimal setting after the video has started.

For your safety, the driver should not watch the video or operate the controls while driving. Please note that watching and operating the video while driving are prohibited by law in some countries.

Note:

For your safety, the MAX675VDII has a safety function which turns off the picture when the car is moving, so only the audio can be heard. The picture can only be watched when the car is stopped and the parking brake is applied.

If “AUDIO ONLY” appears on the screen just after turning on the ACC power of the car, release the parking brake while confirming safety, and then engage the parking brake again.

Basic Operations

Loading a disc

1.Press the [7] (OPEN/CLOSE) button to open the operation panel.

2.Insert a disc into the center of the insertion slot with the label side facing up. The disc plays automatically after loading.

Note:

Never insert foreign objects into the disc insertion slot.

If the disc is not inserted easily, there may be another disc in the mechanism or the unit may require service.

8 cm (single play) discs cannot be used.

CAUTION

CAUTION

For your safety, the driver should not insert or eject a disc opening the operation panel while driving.

Pausing play

1.Press the [p] button or touch the [p] key to pause play.

PAUSE” appears in the display.

2.To resume disc play, press the [p] button again.

Ejecting a disc

1.Press the [7] (OPEN/CLOSE) button to open the operation panel.

2.Press the [o] (EJECT) button to eject disc. “EJECT” appears in the display. The play mode then switches to the TUNER mode.

* If a disc is left in the ejected position for 15 seconds, the disc is automatically reloaded (Auto reload). In this case, however, the play mode will remain set to the TUNER mode.

Note:

If you force a disc into before auto reloading, this can damage the disc.

Watching/Listening to a disc already inserted

1.Press the [SRC] button, and touch the [DVD PLAYER] key to select the DVD PLAYER mode.

Play starts automatically.

If no disc is loaded in the unit, “NO DISC” appears in the display.

34 MAX675VDII

Image 30
Contents MAX675VDII Contents Expanding Systems FeaturesPrecautions Outline of Button and Touchkey OperationControles CONTROLS/COMMANDESTurning the power on Names of Buttons Outline of Button and Touchkey OperationDVD Setup menu DVD Player mode screen∗4When automobile moving Source menuBAL/FAD BAL/FAD screenStatus Speaker SEL Status screen Speaker SEL menuAdjusting the other system settings Monitor ADJWall Color Remote Control Remote control unitInserting the Batteries DVD Player mode Functions of Remote Control Unit ButtonsTUNER/TV/Satellite Radio mode Shared modesFunctions of Remote Control Unit Buttons IPod modeCD changer mode Press to scroll the Disc/Track List screen When SUB zone is selectedControls sound volume for Main zone source Controls audio mute function for Main zone sourceCleaning the liquid crystal panel CleaningCleaning the cabinet Operation panel/GeneralitiesHandling Discs DVD Video Features DVD Video SystemDiscs About the registered marks etcOperations Basic OperationsAdjusting the balance/fader Adjusting the AudioAdjusting the angle of the operation panel Basic Operations Opening/closing the operation panelAdjusting the MID Basic Operations Adjusting the BassAdjusting the Treble Adjusting the non fader output volumeAdjusting the Monitor Adjusting the brightness, color, hue and dimmer levelBasic Operations Adjusting the General Switching Connect connect Setting the voice input line for the cellular phoneCellular phone interrupt setting Basic Operations Performing the system checkSetting your Personal Code Adjusting the ClockSetting the anti-theft function Cats When the Enter Personal Code screen appearsSetting the 2-ZONE function Zone FunctionAbout the 2-ZONE function Basic Operations Monitor image and sound with 2-ZONE ON/OFF Radio Operations Seek tuningManual tuning Listening to the radioAuto store Radio Operations Recalling a preset stationPreset scan Manual memorySelecting the DVD Setup menu Changing DVD System SettingsSetting up the screen size Setting up the angle mark displaySetting up the country code Setting up the audio languageSetting up the subtitle language Setting up the parental levelBasic Operations Operating the DVD menu DVD Video OperationsWatching a DVD-Video Showing the DVD menuSkipping a chapter searching Pausing playbackDVD Video Player Operations Stopping playback Slow playbackRepeat playback Using the title menuScan playback TOP functionSwitching angles DVD Video Player Operations Switching among languagesSwitching subtitles Displaying the playback statusWatching a video CD Skipping a track searchingShowing the V-CD menu for Video CD discs with PBC On/Off of Playback Control Listening to a CDDVD Video Player Operations Searching with a track number Changing audio outputOther various play functions DVD Video Player Operations TOP functionSelecting a track on the Track List screen Displaying CD titlesListening to an MP3/WMA What is MP3/WMA?Precautions when creating an MP3 disc Displaying MP3/WMA TAG titlesIllustration. However, on this unit, folders Playback by selecting a folder and track Direct select modeSelecting a folder/track on the List screen Touch the Back key to return to the Folder List screenDVD Video Player Operations Other various play functions Title list play Other FunctionsEntering titles TunerInternal amplifier cancel function Factory default setting is F.WIDEOther Functions Changing over monitor display size Accessories IPod OperationsControlling the iPod IPod Operations Fast forward and fast backward TOP functionSelecting a list item from a list screen Visual Operations CD Changer OperationsSearching with a track number Watching TV TV OperationsTV functions Watching a videoUsing the Preset List screen TV Operations Recalling a preset stationSetting the TV diver Touch the List key again to return to the previous screenSatellite Radio Operations Tuning mode T-MODE Receiving stations selected by categoryScan function Satellite Radio Operations Presetting a categoryPreset scan Category scanningNavi functions Setting Navi as external input equipmentNavi Operations Navi operationNavi Operations Connecting Other Company’s Image Equipment Changing displayCh Surround Decoder control function DimensionCh Surround Decoder Operations PanoramaCh Surround Decoder Operations DSF mode EQ modeBalance/Fader adjustment Subwoofer volume adjustmentCenter volume adjustment See the subsection Setting up the parental TroubleshootingProblem Cause Measure DVD PlayerTV/VTR When connecting an optional TV tuner, etc Error Displays CD ChangerSpecifications Installation and Wire Connection Manual English Installation Manual Installing the Main Unit in a Nissan Vehicle For Nissan vehicleInstalling the Main Unit in a Toyota Vehicle Vehicles other than Nissan and ToyotaRemoving the Main Unit Fuse 15A Fuse Fuse holder Wireless Headphone CCA-670CCA-673 Ground +12V main powerRear right +12V accessory Front right + Front left + Rear right +Connecting the Accessories Connecting the parking brake cordHDD Navigation Set the SLAVE/STAND Alone switch to the Slave positionFront Channel Amplifier2007/3 Y-YI QZ-6070B