Clarion MAX675VDII owner manual Fuse 15A Fuse Fuse holder

6. CAUTIONS ON WIRING

1.Be sure to turn the power off before wiring.

2.Be particularly careful where you route the wires.

Keep them well away from the engine, and exhaust pipe, etc. Heat may damage the wires.

3.If the fuse should blow, check to see if the wiring is correct.

If a fuse is blown, replace it with a new one of the same amperage rating as the original (15A FUSE).

4.To replace the fuse, remove the old fuse of the power supply cord and insert the new one. (Figure 8)

Note:

•There are various types of fuse holder. Do not let the battery side touch other metal parts.

caution

CAUTION

5.Connect the CeNET extension cable fully and securely until it locks. When the CeNET extension cable is pulled, hold the slide cap part and pull it towards you. (Figure 9)

* When the CeNET extension cable is extended or branches, use extension cable CCA-520 (2.5 m) or CCA-521 (0.6 m), or Y-adapter CCA-519 (each of them is sold separately).

CeNET terminal

Slide cap

CeNET cable (provided with the CD changer)

Figure 9

English INSTALLATION MANUAL

After the connection, fix the cord by a clamp or insulation tape for protection.

Fuse (15A FUSE)

Fuse holder

Figure 8

MAX675VDII 71