Getting Started
Hookups
When connecting the audio cord, be sure to match the
CD player | Amplifier |
LINE OUT | INPUT |
| CD |
L | L |
R | R |
•If you have a Sony receiver (amplifier) equipped with the CONTROL A1 jack
Be sure to connect the player to the CD IN jacks on the receiver (amplifier). When making this connection, set the COMMAND MODE of the player to CD1 (see the illustration below). If you further connect the player and the receiver (amplifier) via the CONTROL A1 jacks with the CONTROL A1 cord (supplied for canadian models only), you can use the Auto Function feature between these components. For details, refer to the supplementary
•If you have a digital component such as a digital amplifier, D/A converter, DAT or MD
Connect the component via the DIGITAL OUT (OPTICAL) connector using an optical cable (not supplied). Take off the cap and plug in the optical cable.
POC-15
Optical cable (not supplied)
CD player | Digital component | ||||||
DIGITAL OUT | DIGITAL INPUT | ||||||
| OPTICAL | OPTICAL | |||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Note
When you connect via the DIGITAL OUT (OPTICAL) connector, noise may occur when you play CD software other than music, such as a
When to use the COMMAND MODE selector
The COMMAND MODE selector is set to CD1 at the factory for normal use. You can control this player by connecting to a Sony CD Player with the player control function, via the CONTROL A1 jacks. When making this connection, set the COMMAND MODE selectors of each player to the appropriate position according to the connected line input jacks. For details, refer to the instructions supplied with the connected player.
COMMAND MODE
CD
1 2 3
When using another Sony CD player together with this player
You can make the supplied remote effective only for this player.
•When using the player equipped with the COMMAND MODE selector:
Set the COMMAND MODE selector of this player to CD1 and that of another player to CD2 or CD3. Then set the CD1/2/3 switch on the remote supplied for each player accordingly.
•When using the player not equipped with the COMMAND MODE selector:
The command mode of the player without the COMMAND MODE selector is set to CD1. Set the COMMAND MODE selector of this player to CD2, and set the CD1/2/3 switch on the remote to CD2.
Setting the VOLTAGE SELECTOR (except for European, Canadian and Singaporean models)
Check that the VOLTAGE SELECTOR on the rear panel of the player is set to the local power line voltage. If not, set the selector to the correct position using a screwdriver before connecting the AC power cord to a wall outlet.
110 - 120 V |
|
|
|
|
|
|
|
| 220 - 240 V |
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
5EN