Onkyo DV-SP506 Hdmi OUT, RS 232 North American model only, Jack, Surr Mode switch

Front & Rear Panels—Continued

AOPTICAL DIGITAL AUDIO OUTPUT [21, 22]

This optical digital audio output can be connected to an optical digital audio input on a hi-fi amp, AV receiver, or surround sound decoder (Dolby Digital, DTS).

BCOAXIAL DIGITAL AUDIO OUTPUT [21, 22]

This coaxial digital audio output can be connected to a coaxial digital audio input on a hi-fi amp, AV receiver, or surround sound decoder (Dolby Digital, DTS) with supplied coaxial digital cable.

CHDMI OUT [19–23]

This HDMI jack outputs digital video and audio and can be connected to an HDMI input on a compatible TV or other component.

DS VIDEO OUTPUT [22, 23]

This connector can be used to connect a TV or pro- jector with an S-Video input.

EVIDEO OUTPUT [22, 23]

This RCA connector can be used to connect a TV or projector with a composite video input.

FCOMPONENT VIDEO OUTPUT [22, 23]

These jacks output component video and can be connected to an component video input on a TV or projector.

GRS 232 (North American model only)

This port is for servicing.

H jack [28]

These (Remote Interactive) connectors can be

connected to the connectors on your other Onkyo AV components for interactive control.

Connecting an cable only does not make the system operational. You must also connect the audio cables as well.

If you’re using RIHD, do not connect anything to these connectors.

IAUDIO OUTPUT [21–23]

These jacks make up the multichannel analog audio output. The D.MIX/FRONT jacks can be connected to a stereo input on a TV, hi-fi amp, or other compo- nent. The 1 and 2 jacks output the same signals, so use either pair. If you use this connection, in the Speaker Configuration (page 52), set the Sub- woofer, Center Speaker, and Surround Speaker set- tings to Off, so that 5.1-channel DVD audio is down mixed into two channels.

If you’re using an AV receiver or surround decoder with a 5.1-channel analog audio input, use the D.MIX/FRONT 2 jacks and the SURR 1 L/R, CEN- TER, and SUBWOOFER jacks.

If you’re using an AV receiver or surround decoder with a 7.1-channel analog audio input, connect the SURR 2 L/R jacks to the surround back L/R input jacks on your AV receiver or decoder, and set the SURR MODE switch to “1+2.” The SURR 1 and SURR 2 jacks output the same signals.

JSURR MODE switch [28]

This switch is used to turn the AUDIO OUTPUT SURR 2 on or off. To use this output, set the switch to “1+2.” The SURR 2 jacks output the same signals as the SURR 1 jacks.

KAC INLET [29]

The supplied power cord is connected here. The other of the power cord should be connected to a suitable wall outlet.

LAV CONNECTOR (European model only) [28]

This SCART output can be connected to a TV or projector with a SCART input. This SCART con- nector outputs 2-channel stereo audio (same signals as the D.MIX/FRONT jacks), composite video, S-Video, and RGB video.

15