Onkyo DV-SP1000 Connecting the Power Cord, Controlling Other Out-of-range Components

Connecting—Continued

Connect the IR receiver to the DV-SP1000/ DV-SP1000E as shown below.

from connecting block

Miniplug cable

Signal flow

IR

IN

OUT

DV-SP1000/DV-SP1000E

Controlling Other Out-of-range

Components

For another component that is out of range of its remote controller, you can use a commercially available IR emitter to retransmit the remote controller signals received at the DV-SP1000/DV-SP1000E’s IR IN, as shown below.

Only remote controller signals received by the DV-SP1000/DV-SP1000E’s IR IN are fed through to the IR OUT. Signals picked up by the DV-SP1000/ DV-SP1000E’s remote control sensor are not.

Connecting the Power Cord

Notes:

• Before connecting the power cord, complete all of the
	necessary audio and video connections.
•	Do not use a power cord other than the one supplied
	with the DV-SP1000/DV-SP1000E, which is designed
	exclusively for use with the DV-SP1000/
	DV-SP1000E and should not be used with any other
	component.
•	Never disconnect the power cord from the
	DV-SP1000/DV-SP1000E while the other end is still
	plugged into a wall outlet. Doing so may cause an
	electric shock. Always disconnect the power cord
	from the wall outlet first.
•	The DV-SP1000/DV-SP1000E (not the Canadian

Connecting block

IR receiver

model) is shipped with the POWER switch in the ON

position ( ). When the power cord is connected for

IR IN
IR OUT	DV-SP1000/
	DV-SP1000E

IR emitter

Remote controller

Other component

Signal flow

Connect the IR emitter to the DV-SP1000/ DV-SP1000E’s IR OUT, and place the IR emitter in front of the other AV component’s remote control sensor (usu- ally located on its front panel), as shown below. See the instructions supplied with the IR emitter.

Other component

		Remote control
from connecting block		sensor
		IR emitter
Miniplug cable
IR	Miniplug
IN
OUT
DV-SP1000/	IR Emitter

DV-SP1000E

Signal flow

the very first time, the DV-SP1000/DV-SP1000E will

go on standby and the STANDBY indicator will light

up.

• To completely shutdown the DV-SP1000/

DV-SP1000E, set the POWER switch to the OFF posi-

tion ( ). (This does not apply to the Canadian model).

DVD CHANGER

MODEL NO. DPC-7.4

AC INLET

1Plug the supplied power cord into the DV-SP1000/DV-SP1000E’s AC INLET.

2Plug the other end of the power cord into a suitable AC wall outlet.

The STANDBY indicator lights up.

The STANDBY indicator comes on only if the POWER switch is in the ON () position. (This does not apply to the Canadian model).

41