Onkyo DV-SP1000 Controlling Other Components, Entering Remote Control Codes, Release both buttons

Controlling Other Components

In addition to controlling the DV-SP1000/DV-SP1000E, the remote controller can also be used to control your TV and VCR. To do this you need to enter the appropriate control codes for your TV and VCR. The remote control- ler can also learn individual commands from another remote controller (see page 91).

			Tx/Learn
ON STANDBY		TV	indicator
STANDBY		I	INPUT
1	2	3	+
			TV CH
4	5	6	-

3

Remote controller

1 2 3

4 5 6

7 8 9

+10 0

Use the number buttons to enter the 4-digit remote control code. If the code is accepted, the Tx/ Learn indicator flashes slowly twice.

If the Tx/Learn indicator flashes quickly three times, the code has not been accepted, in which case you should try again from step 2.

Number
buttons	7		8		9
							TV VOL
	+10		0	CLEAR
	SEARCH	MEMORY		DIMMER			AMP INPUT
	S		M		D		INPUT
			AMP INPUT
	DVD		V1	V 2			V3	TV
			MODE
	DVD	AMP		VCR			TV
							PICTURE	VCR
	ZOOM ON						CONTROL
			ENU	M	EN
	AUDIO	PM				U
		TO
	SEL
	+
	CH
	ZOOM		ENTER				VOL
	L MODE
	-
		RE	TURN		UP
				SET
	DISPLAY						MUTING
	LAST MEMORY STEP/SLOW						RANDOM
	REC LM						RD
	AUDIO	SUBTITLE		ANGLE			RESOLUTION
	AUDIO	SBTTL		ANGLE			RSLTN
	REPEAT		A-B				ASPECT
	REPEAT		A-B				ASPECT
	VIDEO INPUT	VIDEO OFF			LEARNING
	V IN	V OFF		L1			L 2
	OPEN/CLOSE
				L 3			L 4
			RC-563DV

Entering Remote Control Codes

Entering the appropriate remote control code for your TV and VCR will allow you to control them with the DV-SP1000/DV-SP1000E’s remote controller. You’ll need to perform this procedure twice to enter the codes for both your TV and VCR.

1Look up the appropriate remote control code for your TV or VCR.

See “Remote Control Codes” on page 87

2While holding down the [VCR] or [TV] MODE button, press the

Remote controller [STANDBY] button, and then

MODE	release both buttons.
VCR
	TV
	The Tx/Learn indicator flashes slowly
	once, and then remains lit.

STANDBY

Notes:

•The learning mode will be cancelled if you don’t press any buttons for 30 seconds.

•In some cases, not all of the remote controller’s but- tons may work as expected.

•Individually learnt commands for the TV and VCR modes (see page 91) are deleted when a new remote control code is entered.

86