Onkyo DV-SP1000 instruction manual Setting Levels With the Test Tone, AV Synchronization

Configuring the DV-SP1000/DV-SP1000E—Continued

Setting Levels With the Test Tone

1	Use the Up and Down [ ]/[ ]
Remote controller	buttons to select Test Tone, and
	then press the [ENTER] button.
	The Test Tone settings appear onscreen.
ENTER

AV Synchronization

When using progressive scanning you may find that the picture and sound are out of sync. With this setting you can delay the audio to correct this. There are three setup memories (1, 2, 3) for storing settings for up to three components. Memories 2 and 3 are already set at 50 ms, which is a good staring point when compensating for the video delay caused by a typical projector with a built-in scaler.

2

Remote controller

ENTER

Use the Up and Down []/[ ] buttons to select each speaker, press the [ENTER] button, use the Left and Right []/[ ] but- tons to adjust the levels, and then press the [ENTER] button.

A test tone is output by each speaker as it is selected.

Speaker levels can be adjusted in 1 dB steps.

	ON	STANDBY					TV
					I			INPUT
	1			2		3		+
								TV CH
	4			5		6		-
	7			8		9
								TV VOL
	+10			0	CLEAR
	SEARCH	MEMORY			DIMMER			AMP INPUT
	S			M		D		INPUT
				AMP INPUT
	DVD			V1	V 2			V3
				MODE
	DVD		AMP		VCR			TV
								PICTURE
	ZOOM ON							CONTROL
ENTER				ENU	M	EN
	AUDIO		PM				U
		TO
	SEL
	+
	CH
	ZOOM			ENTER				VOL
	L MODE
	-
		RE		TURN		UP			SETUP
					SET
	DISPLAY							MUTING
	LAST MEMORY			STEP/SLOW				RANDOM
	REC LM							RD
	AUDIO	SUBTITLE			ANGLE			RESOLUTION
	AUDIO		SBTTL		ANGLE			RSLTN
	REPEAT			A-B				ASPECT
	REPEAT			A-B				ASPECT
	VIDEO INPUT		VIDEO OFF			LEARNING
	V IN		V OFF		L1			L 2
	OPEN/CLOSE

Speaker	Range	Default
Front Left
Center
Front Right	–12 dB to
		0 dB
Surround
	0 dB
Right
Surround Left
Subwoofer

You cannot set the level of speakers that are set to Off.

3When you’ve finished, press the [SETUP] button to exit setup, or

Remote controller press the Left [] button repeat-

SETUP	edly to go back to the main setup
	menu.

L 3	L 4
RC-563DV

Selecting the AV Synchronization

1 Use the Up and Down [ ]/[ ] buttons to select setup 1, 2, or 3, and then press the [ENTER] or Right [ ] button.

The parameters appear onscreen.

79