NAD L 54 Input Select, Adjusting the Volume, Adjusting the Subwoofer Level Trim on the FLY

Page 14

Setup

SETTING UP THE L 54

ENGLISH

FRANÇAIS

DEUTSCH NEDERLANDS ESPAÑOL

ITALIANO

РУССКИЙ

SVENSKA

DYNAMIC RANGE CONTROL (DRC)

You can select the effective dynamic range (subjective range from soft to loud) for playback of

Dolby 2.0 soundtracks. Settings of 25%, 50% and 75% progressively reduce dynamic range, making soft sounds comparatively louder while limiting the peak loudness of loud ones.

The 100% setting is best for late-night sessions or other times when you wish to retain maximum dialog intelligibility while minimizing overall volume levels. To maintain full dynamic range, set DRC to OFF.

NOTE

To access DRC feature, always set SRS first to OFF.

INPUT SELECT

Aside from the L 54’s internal DVD and tuner section, the L 54 is also equipped with 3 inputs - Audio/ Video inputs labeled “CAB/SAT”, “VCR” and “VIDEO 4 (VIDEO 4 on the front panel). The input becomes active whenever it is selected.

From the front panel, press the “INPUT SELECT” button to toggle from DVD, CABLE/SAT, VCR, VIDEO 4, AM, FM and then back to DVD. If the L 54 is in standby mode, the “STOP/OPEN” button will automatically select DVD mode.

Incoming digital and audio signals present at either digital or analog audio are assigned to their fixed inputs - CAB/SAT and VCR. Assign either coaxial or analog audio to CABLE/SAT input by toggling the L 54’s ‘DISPLAY’ button on the front panel. The selected audio input will be displayed on the VFD after releasing the ‘DISPLAY’ button. The same procedure is applicable when assigning optical or analog audio to the VCR input.

The assigned audio input will always be recalled whenever that input is selected via the front panel INPUT SELECT or the HTR 4 remote’s input-select buttons.

It is not necessary to connect at the same time both analog audio and digital audio input for every video input you employ. It is preferable to make only digital audio link to the L 54 for audio playback. This avoids possible confusion and ensures that the L 54’s high performance digital audio circuitry will always be employed.

ADJUSTING THE VOLUME

In addition to the Volume knob, use the HTR 4’s VOL keys to adjust the volume of the L 54 raising

or lowering the channels altogether. With HTR 4’s VOL keys, a momentary keypress will change

the volume by 1 dB increments. If you hold down VOL keys, the volume level change will “run- on” until the key is released. Since recordings vary considerably in overall average level, there is no imperative to listen at any particular volume setting. A setting of -20 may sound “as loud” from one CD or DVD as -10 does from another.

TheM L 54 will power-up from Standby mode at whatever master volume setting was last used; however, if the prior setting is greater than –10 dB, the L 54 will power up at -10 dB. This prevents inadvertently beginning a session at excessive volume.

muting THE SOUND

Use the HTR 4’s ‘Mute’ key to silence all channels completely. Muting is always available regardless of the source or listening mode selections. Note that adjusting the volume upward via the HTR 4 or the front panel knob automatically releases the mute function.

ADJUSTING THE SUBWOOFER LEVEL TRIM “ON THE FLY”

You can make changes to the relative level of subwoofer output. This may prove useful in a number of circumstances; for example to reduce excessive deep bass (or enhance deep bass) by lowering (raising) the subwoofer level.

Use the HTR 4’s ‘SUB’ keys for direct-access level adjustment of these channels over a range of ±12 dB.

14

Page 13 Page 15
Image 14
Page 13 Page 15
Contents DVD Receiver Important Safety Instructions FCC Notice If the product has been exposed to rain or waterDo not STARe Into Beam FCC WARNIngModel no Serial no Important Information for UK CustomersIf in Doubt ConSULT a Competent Electrician Table of Contents IntroductionQuick Start Unpacking and SetupGetting the Most from the L WHAT’S in the BOXEase of USE About the HTR 4 System Remote ControlAbout the L Identification of Controls Front PanelSCAN/TUNE Pressing momentarily the or button will Rear Panel Deutsch Nederlands Identification of Controls Factory Default Settings SetupSetting UP the L Dealing with HUM and NoiseAbout the ON-SCREEN Display OSD Audio ModeAdjusting the Tone Controls Displaying the L 54 DVD OSDInput Select Adjusting the VolumeAdjusting the Subwoofer Level Trim on the FLY Dynamic Range Control DRCRegion Management Information Using the LOperation About DVD/SVCD/VCD/CDOSD Navigation Using the L 54’S Internal DVD Player Setup MenuSetup Menu TV Aspect RatioSubtitle PasswordLanguage Down SamplingVideo OUT ScanScreen Saver Divx CodeUsing the L 54’S Internal DVD Player Features Random Play ProgrammingPlaying MP3/WMA/JPEG RepeatAssembling the Loop Antenna Setting Radio PresetAbout Antennas Selecting the RadioAbout RDS Deleting a Stored PresetChoosing FM MUTE/MODE Viewing RDS TextControlling the L Using the HTR 4 Remote ControlSpecifications Learning Codes from Other Remotes Copy Command from Another ButtonCancel Operation PUNCH-THROUGHExecuting Macros Macro CommandsRecording Macros Delete Mode Button Illumination TimeoutFactory Reset FlashesNAD-brand component Search ModeLoading Code Libraries Key Checking CODE-LIBRARY NumberSummary of the HTR 4 Modes Device Key +RTN KeyCondition TroubleshootingReference FM Section SpecificationsAM Section InputReference
Top Page Image Contents