NAD L 54 Important Information for UK Customers, If in Doubt ConSULT a Competent Electrician

Page 4

IMPORTANT SAFETY INSTRUCTIONS

ENGLISH

FRANÇAIS

DEUTSCH NEDERLANDS ESPAÑOL

ITALIANO

РУССКИЙ

SVENSKA

IMPORTANT INFORMATION FOR UK CUSTOMERS

DO NOT cut off the mains plug from this equipment. If the plug fitted is not suitable for the power points in your home or the cable is too short to reach a power point, then obtain an appropriate safety approved extension lead or consult your dealer. If, nonetheless, the mains plug is cut off, REMOVE THE FUSE and dispose of the PLUG immediately, to avoid possible shock hazard by inadvertent connection to the mains supply. If this product is not provided with a mains plug, or one has to be fitted, then follow the instructions given below:

IMPORTANT

DO NOT make any connection to the larger terminal which is marked with the letter ‘E’ or by the safety earth symbol or colored GREEN or GREEN AND YELLOW.

The wires in the mains lead on this product are colored in accordance with the following code:

BLUE – NEUTRAL

BROWN – LIVE

As these colors may not correspond with the colored markings identifying the terminals in your plug, proceed as follows:

The BLUE wire must be connected to the terminal marked with the letter ‘N’ or colored BLACK.

The BROWN wire must be connected to the terminal marked with the letter ‘L’ or colored RED.

When replacing the fuse, only a correctly rated and approved type should be used, and be sure to re-fit the fuse cover.

IF IN DOUBT ConSULT A COMPETENT ELECTRICIAN.

NOTES ON ENVIRONMENTAL PROTECTION

At the end of its useful life, this product must not be disposed of with regular household waste but must be returned to a collection point for the recycling of electrical and electronic equipment. The symbol on the product, user’s manual and packaging, point this out.

The materials can be reused in accordance with their markings. Through re-use, recycling of raw materials or other forms of recycling of old products, you are making an important contribution to the protection of our environment. Your local administrative office can advise you of the responsible waste disposal point.

NOTE: The L 54 is not an auto voltage DVD Receiver. Connect only to the prescribed AC outlet, i.e., 120V 60Hz or 230V 50Hz.

This product incorporates copyright protection technology that is protected by method claims of certain U.S. patents and other intellectual property rights owned by Macrovision Corporation and other rights owners. Use of this copyright protection technology must be authorized by Macrovision Corporation, and is intended for home and other limited viewing uses only unless otherwise authorized by Macrovision Corporation. Reverse engineering or disassembly is prohibited.

Manufactured under License from Dolby Laboratories. “Dolby” and the double-D symbol are trademarks of Dolby Laboratories.

“DTS” and “DTS Digital Out” are registered trademarks of DTS, Inc.

RECORD YOur MODEL NUMBER (NOW, WHILE YOU CAN SEE IT) The model and serial number of your new L 54 are located on the back of the cabinet. For your future convenience, we suggest that you record these numbers here:

Model no: __________________________

Serial no.: __________________________

NAD is a trademark of NAD Electronics International, a division of Lenbrook Industries Limited

Copyright 2007, NAD Electronics International, a division of Lenbrook Industries Limited



Image 4
Contents DVD Receiver Important Safety Instructions If the product has been exposed to rain or water Do not STARe Into BeamFCC Notice FCC WARNIngIf in Doubt ConSULT a Competent Electrician Important Information for UK CustomersModel no Serial no Table of Contents IntroductionUnpacking and Setup Getting the Most from the LQuick Start WHAT’S in the BOXAbout the L About the HTR 4 System Remote ControlEase of USE Identification of Controls Front PanelSCAN/TUNE Pressing momentarily the or button will Rear Panel Deutsch NederlandsIdentification of Controls Setup Setting UP the LFactory Default Settings Dealing with HUM and NoiseAudio Mode Adjusting the Tone ControlsAbout the ON-SCREEN Display OSD Displaying the L 54 DVD OSDAdjusting the Volume Adjusting the Subwoofer Level Trim on the FLYInput Select Dynamic Range Control DRCUsing the L OperationRegion Management Information About DVD/SVCD/VCD/CDUsing the L 54’S Internal DVD Player Setup Menu Setup MenuOSD Navigation TV Aspect RatioPassword LanguageSubtitle Down SamplingScan Screen SaverVideo OUT Divx CodeUsing the L 54’S Internal DVD Player Features Programming Playing MP3/WMA/JPEGRandom Play RepeatSetting Radio Preset About AntennasAssembling the Loop Antenna Selecting the RadioDeleting a Stored Preset Choosing FM MUTE/MODEAbout RDS Viewing RDS TextSpecifications Using the HTR 4 Remote ControlControlling the L Copy Command from Another Button Cancel OperationLearning Codes from Other Remotes PUNCH-THROUGHRecording Macros Macro CommandsExecuting Macros Button Illumination Timeout Factory ResetDelete Mode FlashesLoading Code Libraries Search ModeNAD-brand component Checking CODE-LIBRARY Number Summary of the HTR 4 ModesKey Device Key +RTN KeyReference TroubleshootingCondition Specifications AM SectionFM Section InputReference