Learning Codes from Other Remotes, Punch-Through

ENGLISH

FRANÇAIS

DEUTSCH NEDERLANDS ESPAÑOL

ITALIANO

РУССКИЙ

SVENSKA

Operation

USING THE HTR 4 REMOTE CONTROL

LEARNING CODES FROM OTHER REMOTES

Begin by positioning the HTR 4 “nose-to-nose” with the source remote so the two devices’ infrared windows are about 2 inches apart.

•Enter Learning Mode: On the HTR 4, simultaneously press-and-hold for 3 seconds both a Device Selector key and the key until the Learn LED at the center of the HTR 4 turns steady green.

•Press the HTR 4’s function key you wish to teach a command; the Learn LED will turn amber.

•Press-and-hold the function key on the source remote: The HTR 4’s Learn LED will flicker amber for a second or two, then turn solid green. The command is learned.

•Press the HTR 4’s Device Selector key again to exit the learning mode.

If the Learn LED does not flicker amber you may need to vary the distance between the remotes. If the Learn LED turns red rather than green, that particular command of that source remote command could not be learned.

Cancel Operation

You can cancel configuring a key, by pressing the active Device Selector key before the learn process is complete; the Learn LED will turn red.

Example: Learning “DVD Pause”

Position the HTR 4 and your DVD player’s remote as described above.

•On the HTR 4, simultaneously press-and-hold [DVD] and ; the Learn LED turns steady green.

•Press the HTR 4’s key; the Learn LED turns amber.

•Press-and-hold the DVD player’s remote’s pause key; the HTR 4’s Learn LED flickers amber and then turns solid green. The command is learned.

•Press [DVD] again to exit the learning mode.

PUNCH-THROUGH

The HTR 4’s “punch-through” function allows you to retain a function key from one Device Select “page” to another, so that, for example, the AMP [AUDIO MODE] function might still control the L 54 when the DVD Device Selector page is active.

Note

The HTR 4’s [VOL] keys are pre-programmed as “punched-through” for all Device Select pages: [VOL] will operate the L 54’s volume regardless of the currently selected device. The [SUB] level control is similarly pre-programmed as punched-through.

To set a punch through, after entering the Learning Mode, and pressing the desired key to be punched through, simply press the device key twice of the device to punch through to. The status LED will turn green; press the Device Selector key again to exit Learning Mode.

Example: Punch-through AMP [AUDIO MODE] key to the DVD “page”

•On the HTR 4, simultaneously press-and-hold [DVD] and ; the Learn LED turns steady green.

•Press [AUDIO MODE]; the Learn LED turns amber.

•Press [AMP] twice; the Learn LED turns green.

•Press [DVD] again to exit the learning mode.

COPY COMMAND FROM ANOTHER BUTTON

You may copy a command from any HTR 4 key to any other key. To copy a key function, after entering the Learning Mode, and pressing the desired key to be copied to, simply press the device key from which you wish to copy, having first pressed its Device Selector key if it resides on another “page.”The status LED will turn green; press the Device Selector key again to exit Learning Mode.

Example: Copy the Pause command from the CD page to the AMP key:

•On the HTR 4, simultaneously press-and-hold [AMP] and ; the Learn LED turns steady green.

•Press (pause); the Learn LED turns amber.

•Press [CD]; press (pause); the Learn LED turns green.

•Press [AMP] again to exit the learning mode.

Note

The copy and punch-through functions are similar. However, if you copy a command and then subsequently delete, or over-write the original (source-key) command , the copied-to key’s command remains unchanged. If you punch-through to a command and then delete or over-write the original key, the punched-through functions also change accordingly.