NAD L 54 owner manual SCAN/TUNE Pressing momentarily the or button will

Page 9

Identification of Controls

FRONT PANEL

12INPUT SELECT : Use to select an audio/video input along with its

assigned analog or digital inputs Toggle to select through: Internal DVD ➜ CABLE/SAT ➜ VCR ➜ VIDEO 4 ➜ Internal AM tuner ➜ Internal FM tuner ➜ then back to Internal DVD. (See also section about “Input Select” under “Setting up the L 54”).

13VOLUME (SETUP) : Turn clockwise to increase the volume setting; counter clockwise to lower it. The VFD shows the setting displayed as increments between -61 through to 17.

The VOLUME knob is also used to increment/decrement Bass/Treble level, LEFT/RIGHT balance, set DRC level and turn ON/OFF SRS.

14SCAN/TUNE : Pressing momentarily the or button will

manually scan the AM or FM band. Press and hold or for more than 2 seconds to search up or down; the L 54’s tuner will stop at the next sufficiently strong signal it encounters. Note too that this function “wraps,” and will continue searching up or down from one end of the AM or FM band to the other.

Press or during disc playback. Press repeatedly to select the desired scanning speed.

15SKIP/PRESEt :At AM/FM mode, press to step up or down between stored radio presets; 30 FM and 30 AM station presets are available. Note

that this function “wraps”: Pressing or will step from Preset 30 to Preset 1, or vice versa. “Unused” presets are skipped over.

In DVD mode, press to skip forward or to skip backward a track

or chapter. When setting up the Timer, use the or buttons to change the hours and minutes.

16VFD : The Vacuum Fluorescent Display (VFD) provides visual information on all of the L 54’s important modes, settings and functions.

17VIDEO 4 INPUT : Use these convenience jacks for occasional sources such as a camcorder, tape player, video game console or any other analog audio and composite/S-Video video sources. Select the Video 4 input using the HTR 4 remote or through the front panel“INPUT SELECT” button.

If your source has a single audio out jack only or is marked ‘mono output’ , plug this into the L 54’s Video 4 ‘R (Mono)’ input. On the other hand, if your source has two output jacks indicative of stereo output, insert both jacks into the L 54’s corresponding Video 4 ‘L’ and ‘R (Mono)’ input to achieve stereo output as well.

18PHONES : Accepts stereo headphone using a standard 1/4-inch stereo phone plug (use a suitable adaptor for headphones equipped with a smaller plug). Plugging in headphones automatically mutes output from the speakers (but not from the AUDIO OUT jacks of the VCR at SRS OFF).

ENGLISH

FRANÇAIS

ESPAÑOL NEDERLANDS DEUTSCH

ITALIANO

РУССКИЙ

SVENSKA

Page 8 Page 10
Image 9
Page 8 Page 10
Contents DVD Receiver Important Safety Instructions Do not STARe Into Beam If the product has been exposed to rain or waterFCC Notice FCC WARNIngImportant Information for UK Customers If in Doubt ConSULT a Competent ElectricianModel no Serial no Introduction Table of ContentsGetting the Most from the L Unpacking and SetupQuick Start WHAT’S in the BOXAbout the HTR 4 System Remote Control About the LEase of USE Front Panel Identification of ControlsSCAN/TUNE Pressing momentarily the or button will Deutsch Nederlands Rear PanelIdentification of Controls Setting UP the L SetupFactory Default Settings Dealing with HUM and NoiseAdjusting the Tone Controls Audio ModeAbout the ON-SCREEN Display OSD Displaying the L 54 DVD OSDAdjusting the Subwoofer Level Trim on the FLY Adjusting the VolumeInput Select Dynamic Range Control DRCOperation Using the LRegion Management Information About DVD/SVCD/VCD/CDSetup Menu Using the L 54’S Internal DVD Player Setup MenuOSD Navigation TV Aspect RatioLanguage PasswordSubtitle Down SamplingScreen Saver ScanVideo OUT Divx CodeUsing the L 54’S Internal DVD Player Features Playing MP3/WMA/JPEG ProgrammingRandom Play RepeatAbout Antennas Setting Radio PresetAssembling the Loop Antenna Selecting the RadioChoosing FM MUTE/MODE Deleting a Stored PresetAbout RDS Viewing RDS TextUsing the HTR 4 Remote Control SpecificationsControlling the L Cancel Operation Copy Command from Another ButtonLearning Codes from Other Remotes PUNCH-THROUGHMacro Commands Recording MacrosExecuting Macros Factory Reset Button Illumination TimeoutDelete Mode FlashesSearch Mode Loading Code LibrariesNAD-brand component Summary of the HTR 4 Modes Checking CODE-LIBRARY NumberKey Device Key +RTN KeyTroubleshooting ReferenceCondition AM Section SpecificationsFM Section InputReference
Top Page Image Contents