Theta Digital LC3015-2 manual Machine Foundations Cross Section, Foundation plan and side views

Page 30

Machine Foundations Cross Section

These drawings include pockets for the j-bolts (preferred method). If anchors are to be used instead, then the j-bolt pockets may be omitted when preparing the foundation.

21.65

10.6 42.9

184.25

J-Bolt locations

8.25

42.1

10.825"

13.75"13.75"

178.38"

228.25"

Figure 8: Foundation plan and side views

22	LC3015 Theta User Installation Guide - October, 2003

Image 30

Contents Theta LC30152 Document title Applies toRevision history Contents Dust Collectors Table of Figures Electrical connect 230 VAC Pre-Installation Checklist Placement of the Machine and ComponentsItems to be Obtained Electrical Requirements PreparationDescription of the Major Components Major Components Size and Weight of Major Components Basic Specifications Feature SpecificationLaser and Production Cutting Specifications Supply Requirements Other Requirements Air specifications ISO 8573.1 standard ConnectionsLaser Pre-mix Gas BOC GasesPurity Laser Pre-mix Gas SpecificationGas Pre-mix ratios MoistureAssist Gas Recommendations Oxygen PurityGas Assignment Inlet Port Machine Dimensions LC3015 Theta Front View Machine from shuttle endMachine Dimensions LC3015 Theta Side View Machine from operator sideMachine Dimensions LC3015 Theta Plan View Machine from topPlanning The Location of the Machine Chiller Chiller Dimensions Orion ChillerDust Collectors Torit DFT3-18Torit DFT3-18, side view Farr GS-12 Machine Foundations Machine Foundations Cross Section Foundation plan and side viewsFoundation End View Foundation right end viewBolt Detail Lifting Installing The Air Supply Installing The Electrical Power Supply Laser and CNC groundingGrounding resistance Electrical connect 460 VAC Electrical connect 230 VAC LC3015 Theta User Installation Guide October CNC power connect, Figure Power cable Breaker Protective Coatings Version Details Revision historyContact Information Company/group Purpose Phone