Arcam DV29 manual Using the CR-415 remote control

OPEN

Opens and closes the disc tray

This allows direct access to individual tracks on audio CDs. To select a track, press the corresponding keypad button followed by OK. For tracks greater than 9, enter the digits in sequence. For example, to play track 15, press 1, then 5, then OK.

DISP (display)

Dims or turns the DV29’s display on or off. Turning the display off generally gives a slight improvement in sound quality.

Pressing DISP once turns the display off; twice dims the display. To restore the display to full brightness, press DISP a third time.

A–B

This button enables you to repeat a selected section from the disc (see page 19).

RPT (repeat)

Press RPT to cycle through the repeat play options.

Fast play and Skip chapter/tracks

Play fast (7 8) and Skip () chapters/tracks in both directions (see page 8).

SETUP

‘Setup’ allows you to configure the DV29 for use in your system. Ensure that no disc is playing and press SETUP to access the ‘Setup’ menu.

DVD

OPEN 1 2 3

DISP 4 5 6

A–B7 8 9

RPT CLEAR 0 PROG

SETUPMENU

OK

Standby

Press Standby to toggle the standby state of the DVD player. Note that Arcam CD players are not controlled by this button.

CLEAR

Use CLEAR to clear a numeric field.

PROG (program)

You can program a selection of up to 20 chapters/tracks from a disc to play in any order. Press PROG to access the ’Programme’ menu (see pages 20 and 22).

Page Up/Down (DVD-audio)/

Slow play (other discs)

DVD-audio: Some DVD-audio discs allow the user to browse through images (photographs of the artist, lyrics, etc.) while music is being played. Use the or buttons to change to the previous/next page. Note that this is not availble on all DVD-audio discs.

Other discs: Press or on the remote control to play slow forward or backwards. There are four speeds of slow playback: 1/5, 1/4, 1/3 and 1/2. Press the button repeatedly to cycle through the different speeds. To resume normal playback speed, press PLAY.

Note that Slow play does not apply to audio CDs or DVD- audio discs.

Playback control

Pause (;), Play (4) and Stop (<) (see page 8).

Advanced controls

These buttons are described on the next page.

If the player does not respond consistently to the remote control, ensure that the player is configured to respond to the correct remote control type; this is done via the player set-up menu. See page 12 for further details.

If the remote control receiver

AUDIO TRIM TITLE RTN

ZOOM ANGLE SUBT PL

P

MODE STATUS MEM SRCH

CR-415

MENU

Press MENU to access the DVD ‘Disc’ menu.

This navigation menu is specific to a disc and varies for each title, but typically offers facilities to select chapters, languages, and view extra material such as trailers or documentaries.

Once the menu has been accessed, use the cursor pad to move around the menu and press OK to activate a menu ‘button’.

Cursor pad and OK button

Use the cursor pad to navigate the On-Screen Display (OSD) and menu pages. Confirm your selection with the OK button.

MUTE

Stops sound to the speaker outputs of certain Arcam amplifiers.

Volume +/–

Adjusts the volume on Arcam remote-controllable amplifiers.

Note that the volume (+/–) controls and MUTE button have no effect on the audio output level of the DVD players.