Using the CR-415 remote control
OPEN
Opens and closes the disc tray
This allows direct access to individual tracks on audio CDs. To select a track, press the corresponding keypad button followed by OK. For tracks greater than 9, enter the digits in sequence. For example, to play track 15, press 1, then 5, then OK.
DISP (display)
Dims or turns the DV79’s display on or off. Turning the display off generally gives a slight improvement in sound quality.
Pressing DISP once turns the display off; twice dims the display. To restore the display to full brightness, press DISP a third time.
This button enables you to repeat a selected section from the disc (see page 19).
RPT (repeat)
Press RPT to cycle through the repeat play options.
Fast play and Skip chapter/tracks
Play fast (7 8) and Skip (
) chapters/tracks in both directions (see page 8).
SETUP
‘Setup’ allows you to configure the DV79 for use in your system. Ensure that no disc is playing and press SETUP to access the ‘Setup’ menu.
Playback control
Pause (;), Play (4) and Stop (<) (see page 8).
Advanced controls
These buttons are described on the next page.
If the player does not respond consistently to the remote control, ensure that the player is configured to respond to the correct remote control type; this is done via the player
If the remote control receiver
| (located on the right of the front- | |
| panel window) is not ‘visible’ to the | |
| remote control | |
| remote control will not work! Either | |
| locate the unit differently, or take | |
| advantage of the remote control | |
| input on the rear of the player | |
DV79 | (consult your dealer for further | |
information on this option). | ||
DVD
OPEN 
1 
2 
3
DISP 
4 
5 
6
A–B 
7 
8 
9
RPT CLEAR 
0 PROG
SETUPMENU
OK
AUDIO TRIM TITLE RTN
ZOOM ANGLE SUBT PL
P
MODE STATUS MEM SRCH
Standby
Press Standby to toggle the standby state of the DVD player. Note that Arcam CD players are not controlled by this button.
CLEAR
Use CLEAR to clear a numeric field.
PROG (program)
You can program a selection of up to 20 chapters/tracks from a disc to play in any order. Press PROG to access the ’Programme’ menu (see pages 20 and 22).
Slow play
Press 
or 
on the remote control to play slow forward or backwards. There are four speeds of slow playback: 1/5, 1/4, 1/3 and 1/2. Press the button repeatedly to cycle through the different speeds. To resume normal playback speed, press PLAY.
Note that slow play does not apply to audio CDs.
MENU
Press MENU to access the DVD ‘Disc’ menu.
This navigation menu is specific to a disc and varies for each title, but typically offers facilities to select chapters, languages, and view extra material such as trailers or documentaries.
Once the menu has been accessed, use the cursor pad to move around the menu and press OK to activate a menu ‘button’.
Cursor pad and OK button
Use the cursor pad to navigate the
MUTE
Stops sound to the speaker outputs of certain Arcam amplifiers.
Volume +/–
Adjusts the volume on Arcam
Note that the volume