| Getting Started |
|
Accessory List |
| |
• | Head unit | 1 |
• | Power cable | 1 |
• | Mounting sleeve | 1 |
• | Bracket key | 2 |
• Flush Head Screw (M5x8) | 6 | |
• | Screw (M5×8) | 8 |
• | Face plate | 1 |
• | Mounting Position Seal | 2 |
• | Pre OUT Cable | 1 |
• | AUX I/O Cable | 1 |
• | Owner’s Manual | 1 set |
Optional Remote Control Interface Box
This unit is operable using the vehicle’s secondary radio controls. An Alpine Remote Control Interface Box (optional) is required. For details, contact your Alpine dealer.
Location of Controls
Remote Sensor
Point the optional remote control transmitter towards the remote sensor within a range of 2 meters.
/
button
Press to adjust the volume.
MUTE button
Lowers the volume by 20 dB instantly. Press the button again to cancel.
(OPTION) button
Press to recall the setting which is set in “Setting the VISUAL Soft Button” (page 37).
If “V.SEL” is set, the VISUAL SETUP screen will be recalled. If “TEL” is set, the TEL Bluetooth screen will be recalled (when the optional Bluetooth Box is connected).
IMPRINT/AUDIO button
Press to recall the IMPRINT operation screen (When the optional IMPRINT audio processor
Pressing and holding for at least 2 seconds will recall the AUDIO SETUP screen.
SOURCE/
button
Turns the power on. Press and hold for at least 2 seconds to turn the power off.
Recalls the SOURCE selection screen.
10-EN
OPEN button
Ejects a disc.
If the disc does not eject after pressing OPEN, press and hold OPEN for at least 3 seconds.
RESET switch
Be sure to press the RESET switch when using the unit for the first time, after installing the CD changer, after changing the car battery, etc.
Turn off the unit power, press RESET with a ballpoint pen or similar pointed object.
DISC indicator
Lights when a disc is inserted into the unit.
About the button descriptions used in this Owner’s Manual
•The buttons found on the face of the unit are expressed in bold (e.g. SOURCE/
). The buttons found on the
•This Owner’s Manual explains mainly the function of soft buttons, when a soft button and a unit button have the same function.
Turning Power On or Off
Some of this unit’s functions cannot be performed while the vehicle is in motion. Be sure to stop your vehicle in a safe location and apply the parking brake, before attempting these operations.
1 Press SOURCE/
to turn on the unit.
•The unit can be turned on by pressing any button on the unit except OPEN.
2 Press and hold SOURCE/
for at least 2 seconds to turn off the unit.
•Some operation of the unit cannot be performed while the vehicle is in motion. In this case, be sure to first stop your vehicle and apply the parking brake, then perform the operation.
•The