Inserting / Ejecting a Disc
Insert the disc
Press OPEN.
The movable monitor will open. Insert a disc into the Disc slot part.
Inserting a disc will close the monitor automatically.
Disc Slot
Eject the disc
Press OPEN again.
Disc is ejected.
•Do not apply shock to the movable monitor when it is open as it may result in malfunction of the unit.
•The monitor may be dim during low temperature and immediately after turning on the power. The brightness will return to normal as time elapses.
•The monitor will stop at the set tilt angle when closing.
CAUTION
Keep hands (or any other object) away from the monitor while it is opening or closing to avoid damage or injury. The back of the movable monitor will get very warm under normal operating conditions. This is not a malfunction. Do not touch.
Adjusting the Volume
Adjust the volume by pressing 
or 
.
Volume decreases/increases continuously by pressing and holding 
or 
.
Volume: 0 - 35
Lowering Volume Quickly
Activating the Audio Mute function will instantly lower the volume level by 20 dB.
Press MUTE to activate the MUTE mode.
The audio level will decrease by about 20 dB.
Pressing MUTE again will bring the audio back to its previous level.
How to view the Display
Soft button operation
•Be sure to touch the button lightly with the pad of your finger on the display to protect the display.
•If you touch a button and there is no reaction, remove your finger from the display, and try again.
About the button descriptions used in this Owner’s Manual
•Soft buttons, ones found in the display, are shown in bold enclosed in brackets, [ ] (e.g. [SOURCE]).
•Whenever a soft button and a head unit button have the same function, the explanations in this Owner’s Manual will describe the function of the soft button.
Adjusting the Monitor Viewing Angle
Adjust the monitor’s angle for better visibility.
1 Touch [SETUP] for the selected source on the main screen.
The SETUP selection screen is displayed.
2 Touch [DISPLAY SETUP].
3 Touch [
] or [
] of TILT to adjust the desired monitor angle.
Pressing the buttons changes the screen angle by 5 stages.
4 Touch [
] to return to the previous screen.
•This function is adjustable while driving.
•If the monitor touches an obstacle while the angle is being adjusted, the unit stop the screen immediately.
•The screen colour will vary when viewed at certain angles. Adjust the screen angle for the best viewing position.
•If the voltage of the vehicle’s battery power is low, the screen may blink when the screen angle is changed. This is normal and not a malfunction.
•Touching and holding [
] for at least 2 seconds will change to the main source screen.
Recalling the Source
Here is an example explanation for the Radio mode display on how to recall a source.
1 Touch [SOURCE] on the main screen.
The SOURCE selection screen is displayed.
Display example for SOURCE selection screen
Changes to VISUAL selection screen.
Set to VISUAL in “Setting the VISUAL Soft Button” (on page 37).
Changes to SETUP selection screen. Changes to main source screen.
Displays source modes that can be selected
(The kind of source modes that are displayed varies depending on connection and setting).