One-Touch Recording OTR Record Speed | Samsung DVD-V8000 specification

01616A DVD-V8000/TWN-Eng4 8/27/56 8:58 AM Page 50

One-Touch Recording (OTR)

Record Speed

OTR 0:30 0:11:40

OTR 0:30		OTR 0:30
OTR 0:30		OTR 1:00
0:11:40		OTR 1:00
0:11:40		OTR 1:30
SP		OTR 1:30
SP		OTR 2:00
		OTR 2:00
		OTR 9:00
		OTR 9:30


	OTR Loop
	0:11:40
		SP

One-Touch Recording (OTR) allows you to add recording time in 30-minute increments up to 9:30 minutes at the touch of a button.

1Start Recording

Follow the instructions on page 52 to begin recording.

2Activate OTR

While in Record mode, press the REC button again to activate One-Touch Recording (OTR).

•OTR 0:30 appears on the On-Screen Display and the DVD-VCR will record for exactly 30 minutes.

3Add Recording Time

Continue pressing REC to add recording time in 30 minute increments up to 9 hours and 30 minutes.

4Activate Loop Record

When you reach OTR 9:30, press REC again to enter Loop Record mode. The DVD-VCR will record the entire videotape over and over in a continuous loop until you press STOP. This can be used for continuous recording of security cameras.

•If you press Power during OTR, the DVD-VCR will turn off automatically when the recording time has elapsed.

•The DVD-VCR stops recording automatically when the time has elapsed.

You can slow down the recording speed from SP to SLP in order to fit six hours of programming on a T-120 tape.

1Start Recording

Follow the Basic Recording instructions on page 52.

2Set Record Speed

Press the SP/SLP button on the remote control to set the Record Speed to one of the following options:

•SP – Standard Play, for best quality.

•SLP – Super Long Play, for maximum recording time (3 times SP).

NOTE: The selected Record Speed will appear on the front panel display.

Maximum Recording Time - SP vs. SLP

Tape Length	SP (Standard Play)	SLP (Super Long Play)
T-120	2 hrs	6 hrs
T-160	2hrs 40 mins	8 hrs
T-180	3 hrs	9 hrs

0:11:40

Record Source

You can set the DVD-VCR to record from a variety of sources, including the Tuner, DVD deck, Line 1 (front) input, or Line 2 (rear) input. The Auto setting will record whatever is currently visible on-screen, as set by the TV VIEW button.

1Open the “SETUP MENU”

Press the SETUP button on the remote control. The “Setup Menu” appears.

2Select “VCR & Channel Setup”

Using the up/down, move the selection arrow to “VCR & Channel Setup,” then push right to select.

3Set “Record Source”

Move the selection arrow to “Record Source,” then push right to

select from the following options. The VCR will record from:

•Auto – Whatever is currently visible on screen.

•Tuner – The VCR’s built-in television tuner.

•Line 1 – An external source, such as a camcorder, connected to the front line inputs.

•Line 2 – An external source, such as a Satellite receiver, connected to the rear line inputs.

•DVD – A DVD playing in the DVD deck.