Fixing the PDP panel to the wall attachment panel bracket
1 Remove the screws on the rear of the PDP panel.
2 Connect insulation holders to screws (see the illustration below).
• If you are uncertain about installation, hire an Installation Specialist to install the wall mount bracket.
• Be sure to check that the insulation holders are completely secured on both the left and right side after hanging the PDP on the wall mount bracket.
• Be careful to avoid getting your fingers caught during installation.
• Make sure the wall attachment panels are tightened. Otherwise the PDP may fall.
3 Tighten the screws of the Insulation holders to the back of the PDP.
Note
• A 5 inch(12.7 cm) gap is needed between the back of the Plasma TV and the wall.
Put the 4 insulation holders on the PDP in the grooves of the wall mount bracket and
4 pull down on the PDP (Œ) to secure it to the wall mount bracket. (´) Tighten the screws as shown (ˇ) so that the PDP cannot be separated from wall mount bracket.
PDP panel
ˇ
Œ
´
Wall attachment panel bracket | Wall | 31 |