Samsung HP-P5091 manual Setting Up your Remote Control

Setting Up your Remote Control

This PDP's remote control can operate almost any VCR, Cable box or DVD. After it has been set up properly, your remote control can operate in four different modes : TV, VCR, CATV, or DVD. Pressing the corresponding button on the remote control allows you to switch between these modes, and control whichever piece of equipment you choose.

Notes : ● The remote control may not be compatible with all DVD Players, VCRs, Cable boxes.

●The remote control can only operate Set-Top Boxes made by Samsung.

Setting Up the Remote to Operate Your VCR, Cable box or DVD player

1 Turn off your VCR. (or Cable box, DVD player)

Press the MODE button. The Mode is changed

2 whenever the MODE button is pressed (New mode is displayed on LCD screen).

3 Press the SET button on your TV's remote control.

Using the number buttons on your remote control,

4 enter the three digit code for your VCR (or Cable box, DVD player) listed on page 46 of this manual for your brand of VCR (or Cable box, DVD). Make sure you enter all three digits of the code, even if the first digit is a “0”. (If more than one code is listed, try the first one.)

Press the POWER button on the remote control.

5 Your VCR (or Cable box, DVD) should turn on if your remote is set up correctly. If your VCR (or Cable box, DVD) does not turn on after set up, repeat steps

2, 3, and 4, but try one of the other codes listed for your brand of VCR (or Cable box, DVD).

If no other codes are listed, try each code, 000 through 089 (or Cable box: 000 through 077, DVD player: 000 through 008).

Notes

•When your remote control is in “VCR”, “CATV”, or “DVD” mode, the VCR control buttons (STOP, REW, PLAY/PAUSE, and FF) still operate your VCR.

•You do not need to program the remote for Samsung Set-Top Box as the codes are pre-programmed.

45