Samsung HP-P5091 manual Storing Channels in Memory Automatic Method, Std Hrc Irc

Storing Channels in Memory (Automatic Method)

First, select the correct antenna (Air and Cable).

1 See steps on previous page. Press the MENU button. Press the ▲ or ▼ button to select “Channel”,

then press the ENTER button.

Press the ▲ or ▼ button to select “Auto Program”,

2 then press the ENTER button.

➤Quick way to access the Automatic Channel Setting:

Just press the “AUTO PROG.” button on the remote control.

Press the ▲ or ▼ button to select the correct signal

3 (Air, STD, HRC, and IRC). Select an option and then press the ENTER button.

If you are connected to an antenna (Air), leave “Air” displayed. If you are connected to a cable, press the ▲ or ▼ button to display the type of cable system “STD”, “HRC” or “IRC”. (If you are not sure which type of cable system you have, contact your cable company).

Press the ENTER button.

4 The PDP will begin memorizing all of the available channels. After all the available channels are stored, the Auto program menu reappears. Press the MENU button to stop.

Note

• Auto Program may take a few minutes to process.

TV		Channel
	Select Antenna	: Air	√
	Auto Program		√
	Add/Delete		√
	Fine Tune		√
	Signal Strength		√
	Move	Enter	Return
TV		Channel
	Select Antenna	: Air	√
	Auto Program		√
	Add/Delete		√
	Fine Tune		√
	Signal Strength		√
	Move	Enter	Return
TV	Auto Program
	Air
	STD
	HRC
	IRC
	Move	Enter	Return

Auto Program

It will take about several minutes.

Would you like to continue?

Start

Enter Return

Auto Program

Air Ch 23

Stop

Enter Return

36