Toshiba 52HMX94 Frequent or continuous, unplug the power cord, Digital Light Processing Units

Page 4

Installation (continued from previous page)

27)Always make sure the antenna system is properly grounded to provide adequate protection against voltage surges and built-up static charges (see Section 810 of the National Electric Code).

Care (continued from previous column)

33)For added protection of your TV from lightning and power surges, always unplug the power cord and disconnect the antenna from the TV if you leave the TV unattended or unused for long periods of time.

Ground clamp

Electric service equipment

Ground clamps

Antenna lead-in wire

Antenna discharge unit (NEC Section 810-20)

Grounding conductors (NEC Section 810-21)

Power service grounding

electrode system (NEC Art 250 Part H)

34) During normal use, the TV may make occasional snapping

 

or popping sounds. This is normal, especially when the

 

unit is being turned on or off. If these sounds become

 

 

frequent or continuous, unplug the power cord

 

 

 

and contact a Toshiba Authorized Service Center.

 

 

35)

Special care for DLP

TM

(Digital Light Processing

TM

)

 

 

 

units:

 

 

 

 

 

Lamp—The lamp in this product has a limited service life.

 

The length of service life varies depending on product

 

use or user settings. If you use the lamp beyond its

 

 

service life:

 

 

 

 

28)DANGER: RISK OF SERIOUS PERSONAL INJURY OR DEATH!

• Use extreme care to make sure you are never in a position where your body (or any item you are in contact with, such as a ladder or screwdriver) can accidentally touch overhead power lines. Never locate the antenna near overhead power lines or other electrical circuits.

Never attempt to install any of the following during lightning activity: a) an antenna system; or b) cables, wires, or any home theater component connected to an antenna or phone system.

Care

For better performance and safer operation of your TOSHIBA TV, follow these recommendations and precautions:

29)Always sit approximately 10–25 feet away from the TV and as directly in front of it as possible. The picture can appear dull if you sit too far to the left or right of the TV, or if sunlight or room lights reflect on the screen. Turn the TV off to check for reflections on the screen, and then remove the source of reflections while viewing the TV.

30)Always unplug the TV before cleaning. Never use liquid or aerosol cleaners. Clean only with a soft, dry cloth.

Do not spray volatile compounds such as insecticide on the cabinet. This may cause a discoloration or damage of the cabinet.

31)WARNING: RISK OF ELECTRIC SHOCK!

Never spill liquids or push objects of any kind into the TV cabinet slots.

32)If the air temperature rises suddenly (for example, when the TV is first delivered), condensation may form on the lenses. This can make the picture appear distorted or the color appear faded. If this happens, turn off the TV for 6 to 7 hours to allow the condensation to evaporate.

-you may notice a reduction in the colors and/or brightness of the picture, at which time you should replace the lamp unit; and

-the strength of the quartz glass in the lamp will be reduced and the lamp may rupture. If the lamp ruptures, the TV will not operate until the lamp unit is replaced.

See “Lamp unit replacement and care” on pages 98–100. Note:

The lamp unit is designed so broken lamp glass remains securely inside the lamp unit.

The lamp unit contains mercury. Disposal of

mercury may be regulated due to environmental considerations. For disposal or recycling information, please contact your local authorities or the Electronic Industries Alliance (www.eiae.org).

Dispose of the used lamp unit by the approved method for your area.

Service

36)

WARNING: RISK OF ELECTRIC SHOCK!

 

Never attempt to service the TV yourself,

 

except as specified on pages 98–100.

 

Opening and removing the covers may expose you to

 

dangerous voltage or other hazards. Failure to follow this

 

WARNING may result in death or serious injury. Refer all

 

servicing not specified in this manual to a Toshiba Authorized

 

Service Center.

37)If you have the TV serviced:

Ask the service technician to use only replacement parts specified by the manufacturer.

Upon completion of service, ask the service technician to perform routine safety checks to determine

that the TV is in safe operating condition.

38)When the TV reaches the end of its useful life, ask a

qualified service technician to properly dispose of the TV.

Note: The lamp unit contains mercury. Disposal of mercury may be regulated due to environmental considerations. Dispose of the used lamp unit by the approved method for your area. For disposal or recycling information, please contact your local authorities or the Electronic Industries Alliance (www.eiae.org).

4

HMX94(E)002-04

4

9/28/04, 10:12 AM

52/62HMX94

Image 4
Contents 52HMX94 62HMX94 Disposal of mercury may be regulated due to Safety Precautions62HMX94 Important Safety Instructions Installation, Care, and ServiceFor replacement of the obsolete outlet DAMAGE! Never place the TV onFrequent or continuous, unplug the power cord Length of service life varies depending on productService life See Lamp unit replacement and care on pages 98-100. NoteContents Using the TV Guide On Screen 106Features of your new TV IntroductionWelcome to Toshiba See Important notes about yourEnter Connecting your TV Power is OFF. This is called standby modeTV off or on, press this button to reset the TV TV front touchpad and side panel controls and connectionsTV back panel connections For an explanation of cable types, seeOverview of cable types To a Personal Computer PCYou will need For more information, call your local cable operatorTo view encrypted digital channels Connecting a VCR and antenna or Cable TV no Cable box Connecting a camcorderTo use the TV Guide On Screen recording features To view the VCRConnecting a VCR and Cable box On Screen recording featuresTo view basic and premium Cable channels From Cable TVConnecting a VCR and satellite receiver Three coaxial cablesSelect the ColorStream HD-1 video input Source on the TVTo view the DVD player To view premium Cable channelsTo view VCR To record a TV program while watching a DVD To view antenna or Cable channelsFrom antenna or Cable To view the antenna or Cable signal Connecting two VCRsTo dub or edit from VCR 1 to VCR Connecting an Hdmi or a DVI device to the Hdmi input One Hdmi cable type a connector for each deviceTo connect an Hdmi device, you will need To connect a DVI device, you will needConnecting a digital audio system Connecting an analog audio systemOne optical audio cable To control the audioTo connect the IR blaster cable TheaterNet on-screen device controlTo control the devices Connecting IEEE-1394 video devices Using analog-compatible IEEE-1394 devicesSupported signals Using TheaterNet on-screen device controlWhen you connect a D-VHS or Avhd device to the TV You can connect an IEEE-1394 compatible D-VHS or AvhdOther networked IEEE-1394 devices, if any, Audio/video hard drive digital recorder such as Toshiba’sIEEE-1394 device management To edit the IEEE-1394 device informationFor details on setting up the TV Guide On Screen system LINKconnectionTo connect to the G-LINK jack See ChapterUsing the remote control Learning about the remote controlSleep accesses the sleep timer 51/57/65H94To install the remote control batteries Installing the remote control batteriesDevice mode control after programming Remote Control functional key chart PowerAudio VCR Mute Device code setup Press Mode to select the TV mode to control the TVPress Mode to select the mode you want to set up Searching and sampling the code of a deviceUsing the volume lock feature Operational feature resetRepeatedly press Mode to select CABLE/SAT mode To reset the volume controls to the original device modeVCRs/PVRs Multi-brand remote control device codesCable boxes CD players ReceiversLaser disks DVD playersMenu layout and navigation Main menu layoutSetup / Installation menu layout Navigating the menu systemConfiguring the location of your TV TV Guide On Screen system setupTo set up the TV Guide On Screen system Setting up the TV Guide On Screen system On nextHMX94E036-395-TVGsetup 27/04, 1044 AM TV Guide On Screen Reminder Setting up your TV Configuring the antenna input sourcesTo configure the ANT 1 and ANT 2 input sources Selecting the menu languageProgramming channels automatically Programming channels into the TV’s channel memoryTo program channels automatically Manually adding and deleting channels in the channel memory Programming your favorite channels To add and delete channels in the Favorite Channels listsTo clear your favorite channel lists To tune your favorite channels for the current ANT inputSetting up and using TheaterNet on-screen device control Setting up TheaterNetTo set up TheaterNet device control To remove a device from TheaterNetTo close the on-screen control icons To select the device’s control icons directlyTo view another source TheaterNet IR device codes AmplifiersLaser disk players Miscellaneous audio devicesVideo accessory Hdtv decoder Receivers VCRsSTS Setting the Hdmi audio mode Setting the time and dateTo select the Hdmi audio mode To set the Avhd device skip timeSetting the Quick Restart feature To set the Quick Restart featureViewing the CableCARD menu To view the CableCARD menuRestore Factory Defaults Viewing the digital signal meterViewing the system status Using the TV Guide On Screen interactive program guide To open the TV Guide On Screen systemTV Guide On Screen remote control functions Navigating the TV Guide On Screen systemVideo Window Panel MenusLock/unlock icon indicates the status of the Video Window To lock/unlock the Video WindowTV Guide On Screen Icons Info Box¥ Show is presented in high-definition TV, if available Listings screen TV Guide On Screen ServicesEpisode Options panel menu Search screen Example Category searchList of all matching shows for that keyword is displayed Example Keyword searchTo edit or delete a keyword Recordings screen To choose the way recordings are displayedTo view a recording, you can do one of the following Screen a Screen BSet a show to Record from a panel menu Record featuresSchedule screen Manually set a show to Record Recording notification bannerRecord conflict Record iconsSet a show Reminder from a panel menu Remind featuresManually set a show Reminder Remind conflict Reminder notification bannerRemind icons Change system settings Setup screenChange channel display Change default options General default optionsRecord defaults Remind defaultsUsing the TV’s features Selecting the video input source to viewTo select the video input source to view Channel zyTo label the video input sources Labeling the video input sourcesTo clear the input labels Tuning channels Tuning to the next programmed channelSwitching between two channels using Channel Return Switching between two channels using SurfLockPress PIC Size on the remote control Selecting the picture sizeNatural picture size To select the picture sizeNone of the picture is hidden TheaterWide 1 picture size For 43 format programTheaterWide 2 picture size for letter box programs Full picture size for 169 480i, 480p source programs onlyUsing the auto aspect ratio feature To set the scroll settingsTo turn on the Auto Aspect feature To turn off the Auto Aspect featureSelecting the lamp mode To set the Cinema Mode to FilmTo set the Cinema Mode to Video To select the lamp modeUsing the POP features Using the POP double-window featureTo display a program in the POP window To close the POP windowFreezing the main picture in the POP double-window Switching the speaker audio main or POPTo close the still POP window POP double-window aspect ratio Using the favorite channel scan featureTo scan and tune your favorite channels Adjusting the picture Selecting the picture modeAdjusting the picture quality Resetting the picture settingsSelecting the color temperature Using CableClear DNR digital noise reductionResetting the advanced picture settings Advanced closed captions Using the closed caption modeDigital closed captions Adjusting the audio Muting the soundDigital audio selector Selecting stereo/SAP broadcastsUsing the StableSound feature Turning off the built-in speakersUsing the SRS WOW surround sound feature Selecting the optical audio output formatMemory card specifications Using the memory card Jpeg picture viewer/MP3 audio player3V memory card Using the Jpeg picture viewer To view digital photos on your TVPress During the slide showUsing the MP3 audio player To set the slide show intervalTo close the picture viewer To close the picture viewer and remove the memory cardUsing the Game Mode feature Using the MP3 audio player contnuedUsing the memory card Jpeg picture viewer/MP3 audio player Memory card care and handlingSetting the ON/OFF timer Setting the sleep timerDisplaying TV setting information on-screen Understanding the auto power off featureUnderstanding the last mode memory feature Chip rating status Picture size Lamp modeUsing the Locks menu Entering the PIN codeIf you cannot remember your PIN code Changing your PIN codeBlocking TV programs and movies by rating V-Chip To block and unblock TV programs and moviesPress z to highlight Edit Rating Limits and press Edit Rating Limits screen below appearsUnlocking programs temporarily Blocking channelsLocking video inputs Using the GameTimer Using the front panel lock featureTroubleshooting Set to SAP mode Restore Factory Defaults procedure as described onClosed caption problems Caption featureLED indications TV Guide On Screen FAQs SetupWhy aren’t all my channels initially displayed? How do I resize or close the Info window? OperationsLamp unit replacement and care When to replace the lamp unitAppendix Replacing the lamp unitHow to replace the lamp unit Grasp the lamp unit handle and gently pull the lamp unitDisposing of the used lamp unit U.S., call Customer Service atReplace the thumb screw and hand-tighten Specifications Television SystemLimited United States Warranty For DLP Television ModelsLimited Canada Warranty Products Purchased in Canada and Used in the U.S.A. are104 105 Index Picture adjustments Remote controlPicture-out-picture POP 32-33Toshiba America Consumer PRODUCTS, L.L.C 04-11 R1