Toshiba 52HMX94 owner manual Tuning channels, Tuning to the next programmed channel

Chapter 8: Using the TV’s features

Tuning channels

Tuning to the next programmed channel

To tune to the next programmed channel:

Press CHANNEL y or z on the remote control or TV front panel.

Note:

•This feature will not work unless you program channels into the TV’s channel memory (see page 41).

•If you use the TV’s remote control to start recording, you will not be able to change the channel during recording.

If you use a device other than the TV’s remote control to start recording and then change the channel, the recorded audio and video will be that of the currently tuned channel.

Using SpeedSurf to change to a specific programmed channel

Note: This feature will not work unless you program channels into the TV’s channel memory (see page 41).

1.Press and hold CHANNEL y or z for a few seconds. The TV will enter SpeedSurf mode.

		Upper channels
		↑
1 6	T B S
1 3	E S P N	Current channel (highlighted)
1 1	F O X
7	C B S
4	C N N	↓
		Lower channels

Channel label

2.Repeatedly press or hold CHANNEL y or z while the SpeedSurf mode is on-screen to scroll through the channel list. Release the button to display the highlighted channel.

Tuning to a specific channel (programmed or unprogrammed)

Tuning analog channels:

Press the Channel Number buttons (0–9) on the remote control. For example, to select channel 125, press 1, 2, 5.

Tuning digital channels:

Press the Channel Number buttons (0–9) on the remote control, followed by the – (dash) button and then the sub-channel number.

For example, to select digital channel 125-1, press 1, 2, 5, –, 1.

Note: If a digital channel is not programmed—either through the automatic channel scan (page 41) or the channel add/delete function (page 42)—you will have to tune the RF channel using the Channel Number and Dash buttons on the remote control.

Switching between two channels using Channel Return

The Channel Return feature allows you to switch between two channels without entering an actual channel number each time.

1.Select the first channel you want to view.

2.Select a second channel using the Channel Number buttons (and the dash (–) button if selecting a digital channel).

3.Press CH RTN on the remote control. The previous channel will display.

Each time you press CH RTN, the TV will switch back and forth between the last two channels that were selected.

Note: If you press CH RTN from a non-antenna input, the TV will return to the last-viewed ANT input and channel.

Switching between two channels using SurfLock™

The SurfLock™ feature temporarily “memorizes” one channel in the CH RTN button, so you can return to that channel quickly from any other channel by pressing CH RTN.

To memorize a channel in the CH RTN button:

1.Select the channel you want to program into the CH RTN button.

2.Press and hold CH RTN for about 2 seconds until the message “Channel Memorized” appears on the screen. The channel has been programmed into the CH RTN button.

3.Continue to change channels until your desired channel is selected.

4.Press CH RTN. The memorized channel will be selected.

The TV will return to the memorized channel one time only. Once you press CH RTN and then change channels again, the CH RTN button memory will be cleared and the button will function as Channel Return, by switching back and forth between the last two channels that were selected.

		Channel Numbers
ACTION	+10	Ñ (dash)
	100
	–

MENU

ENTER

CHANNEL y / z

CH RTN

68		Copyright © 2004 TOSHIBA CORPORATION. All rights reserved.
HMX94(E)066-75(8a-UseTV)	68	9/28/04, 11:00 AM

(E) 46/52/62HM94