Toshiba 62HMX84, 52HMX84 owner manual Locking channels, Unlocking programs temporarily

Unlocking programs temporarily

1.If you try to watch a TV program that exceeds the rating limits you set, the TV enters program lock mode. After 4 seconds, the TV starts the auto favorite channel search function (page 39).

You can either unlock the program temporarily (see steps 2–4 below) or select a non-locked program to watch.

Introduction

THIS PROGRAM HAS BEEN BLOCKED! TV–PG L V

EXCEEDS SET L I M I TS

PUSH MUTE TO ENTER PI N

CABLE 9

After 4 seconds

2	3	4	5
6	7	8	9
			X
10	11	12	13

Connecting yourTV

2.To temporarily unlock the program, press MUTE while the message is on the screen.

3.Press the Number buttons (0–9) to enter your 4-digit PIN code.

BLOCK I NG ACTI VE

ENTER P I N CODE

TO TEMPORARI LY UN–BLOCK

– – – –

0 – 9 : TO SELECT ENTER: TO SET

4.Press ENTER.

If the correct code is entered, the program lock mode is released and the normal picture appears.

All locking is disabled until the TV is turned off, and will be enabled when the TV is turned on again.

TV							POWER
CABLE/SAT			LIGHT		SLEEP
VCR
DVD			1			2	3
AUDIO1			4			5	6
AUDIO2
MODE
			7			8	9
PIC SIZE			+10
						0
ACTION			100/				ENT
MENU			O	FAV		ORI
			NF				T
		I				TE
							HE
E							LI	AT
									E
ID							N			R
U								K
G			LE	SUB	TIT
			TIT
	P					LE	A
	U						U
T			FAV				DI
SE							O
			ENTER
			FAV
CH							VOL
			EXIT
DVD RTN			DVD CLEAR
CH RTN			INPUT	RECALL			MUTE

SLOW/DIR SKIP/SEARCH

Channel Number

ENTER

yzx •

MUTE

Usingthe	RemoteControl
Settingup	yourTV

Locking channels

With the CH LOCK feature, you can lock specific channels. The TV will not be able to tune locked channels with the Channel y z buttons or Channel Number buttons, unless you clear the setting.

You can lock a maximum of nine channels. To lock channels:

1.From the LOCKS menu, press y or z to highlight CH LOCK, and then press ENTER.

CH LOCK menu appears, and CH INPUT will be highlighted.

2.Press the Channel Number buttons to enter the channel you want to lock.

LOCKS menu

V - CH I P	LOCKS
CH LOCK		OFF
V I DEO LOCK
NEW P I N CODE
: MOVE	ENTER : START

UsingtheTV’s Features

3. Press ENTER.

CH LOCK

CH I NPUT			12
	– – –	– – –	– – –
	– – –	– – –	– – –
	– – –	– – –	– – –

TV CABLE

CLEAR ALL

LOCKS MENU

0–9 : SELECT ENTER : SET

CH LOCK

CH I NPUT			– – –
	12	– – –	– – –
	– – –	– – –	– – –
	– – –	– – –	– – –
			TV CABLE
CLEAR ALL
LOCKS MENU

0–9 : SELECT ENTER : SET

Note:

After programming CH LOCK, change the channel before turning off the TV.

Appendix

4. Repeat steps 2 and 3 for other channels.

Index

43