Specifications

Model name	P600DL
Type	60-inch rear projection unit
Acceptable signals	Refer to page 13 and page 14.
Image device	1 chip XGA Digital Mirror Device (R)
Light source	120W UHP lamp
Resolution	1024 x 768 dot (Include part hidden with screen frame)
Brightness	300cd/m2 (Typ.)
Screen	Fresnel sheet (internal), Lenticular sheet (external)
Screen frame	0.7mm average
Viewing Angle	Horizontal: Min. 150 degrees, Vertical: Min. 60 degrees
Color temperature	Selection of three user defines
Operating temperature	5-35 ℃ (41-95 ○F)
Operating humidity	30-70 % (Relative humidity non-condensing)
Power requirement	AC100-240V, 50/60Hz, 200W (200VA)
Dimensions	1200.6 (W) x 1161.9 (H) x 754.7 (D) mm (48 x 45.7 x 29.3 inches)
	protrusions not included
Weight	70kg
Accessories	Owner’s Manual, DVI link cable, RS232C link cable, Assembly parts

Video Input	Terminal	Not available (Optional Video Input Card : BNC IN/OUT)
	Level	(Optional Video Input Card : 1.0Vp-p composite video, PAL/NTSC)
RGB Input	Terminal	RGB-1 input / RGB-2 input: HD D-sub 15pin (female) connector x 2
	Level	R/G/B signal: 0.7Vp-p (75-ohm termination)
		H.SYNC / V.SYNC / C.SYNC signals: TTL
External control		System: RS-232C, Terminal: D-sub 9pin (female) connector x 1
		Speed: 1200, 2400, 4800, 9600 baud
Communication Link		System: RS-232C, Terminal: D-sub 9pin connector x 2 for IN and OUT
Digital Signal Link		System: TMDS, Terminal: DVI-D 24pin connector x 2 for IN and OUT
Remote Control Terminal		3.5mm terminal for optional Remote Controller

The Digital Signal Link is used for signal transmission between projection units and this does not support external input signal.

The specifications and design of this product are subject to change without notice.