Toshiba P600DL service manual For servicing, maintenance and inspection

Page 6

SAFETY PRECAUTIONS FOR USER

For servicing, maintenance and inspection

WARNING

If dust and dirt attached on the blades or the blade clamping face of the power plug, clean the dust and dirt from the plug.

Otherwise, fire may occur due to lowering of insulation of the power plug.

CAUTION

Make a maintenance contract with the dealer and entrust the dealer with periodical inspection and adjustment.

If the equipment is left for long time without cleaning dust inside the equipment, fire, electric shocks, trouble of the equipment may result.

Servicing of the equipment shall be done after disconnecting the power plug from the outlet. Otherwise electric shocks may result.

Pay attention for the connection cables.

Injury may occur by being caught by or stumbling on the cables. In addition, the equipment may fall down, resulting in injury.

Items to be confirmed with the qualified vendor for installation works

WARNING

Do not use the equipment outdoors, fire or electric shocks may result. This equipment has been designed exclusively for indoor use.

Do not install the equipment on unstable places.

The equipment may drop or fall down, resulting in injury. Install the equipment on a rigid and level floor.

Confirm that the installation works are done for sufficient withstanding force against the overall load of piled-up units and vibration of earthquake, etc. If the installation is unstable, the equipment may drop or fall down, resulting in injury.

Do not install the equipment at places exposed to direct sunshine, or where temperature rises, such as a place near heater, etc.

If the temperature inside the equipment rises, fire may result.

Do not use the equipment in places with high humidity, such as a bathroom or a place near a humidifier.

It may cause fire or electric shocks. Also, the screen may be broken, resulting in injury.

Do not use the equipment with power voltages other than the one indicated on the equipment. Otherwise, fire or electric shocks may result.

Make sure to install a circuit breaker in the power supply line exclusively for the equipment. Otherwise, fire may occur because power supply cannot be cut off immediately when trouble or abnormality occurs in the equipment.

The socket-outlet shall be installed near the equipment and shall be easily accessible.

5

Image 6
Contents P600DL Safety Precaution Contents Safety Precautions for User For use of the equipment For servicing, maintenance and inspection Safety Precautions for User Precautions for USE and Maintenance Request to UserGeneral Descriptions Features Dimensions Function of I/O Panel BNCFunction of Power Panel Power Switch and Power IndicatorON/OFF Specifications Acceptable Signal Type Acceptable RGB Input Signal Timing Horizontal Timing Vertical TimingUnit-4Unit-3 Connection AT a Multi Projection SystemDisassembly HOW to Replace the LampDiassembly Power Supply Module Ballast Module Control Module .LOCATION of KEY Components and Function ModuleExploded View of the Projection Block 96pin connector .EXPLODED View of the Screen Block and Cabinet .WIRING Adjustment .ENGINE Mount Adjustment Adjustment Adjustment Adjustment Colour , Tint Multiple Screen Wall system example Electronic Circuit Explanation Electric Circuit Explanation Stanby Power FAN LampPower on FAN StopAppendix-2 Cont VN2 ID.CLR DMD Driver Board Debug Page Debugging Flow Diagram DMD Driver BoardBad image- Horizontal bands or lines Image shifted to left Parts List Location No Description 94800807 Ballast Module Assy 100W