Colour , Tint

ADJUSTMENT

3-8. Clock frequency adjustment and phase adjustment

Supply fine pitch signal (such as Windows shut-down screen) and adjust CLOCK and PHASE to eliminate moiré and jitter.

3-9. Image position adjustment

Initially image position should be adjusted using the mechanical adjustments so that all unmagnified images appear at the same position. Use POSI to electronically shift the image and CAP to select the position of the image for magnification.

3-10. Screen Mode Selection

Incoming signals are automatically synchronized and the relevant timing data is stored in memory so that this data can be read out each time a particular source is recognized. RGB1 and RGB2 settings are memorized separately. There are a total of 10 memory areas available, if additional frequencies are supplied the earlier settings will be lost.

Auto-adjustment can be switched on or off by pressing SPECIAL and then 1

3-11. On-Screen-Display, OSD

The default condition is for the OSD to be on, this can be switched off by pressing the CALL button in Adjust Mode.

It is possible to change the color of the OSD:

SPECIALA = red, SPECIALB = green, SPECIALC = blue, SPECIAL8 = white.

3-12. Video Enhancer

When video input is selected the following adjustments are available: (NTSC only) and SHARP

3-13. Interpolation Filter

Filtering can be switched on and off by pressing SERVICE and then 4

3-14. Image direction

The image orientation can be flipped up, down, left and right using the FLIP key.

3-15. Status Indication

Pressing CALL in Normal Mode will display general information such input selection and source frequency.

Pressing SPECIAL and then D in Adjust Mode will display software version and date. SPECIALF will display the lamp timer and SPECIALE will display lamp history.

3-16. Power ON delay

This can be set in intervals of 0.5secs by pressing SPECIAL9