Toshiba P600DL service manual Multiple Screen Wall system example

Page 30

ADJUSTMENT

4. Multiple Screen Wall system (example)

Unit-3Unit-4

Unit-2Unit-1

Digital Signal Link

System Bus Link

Signal source Remote controller

5. ID Assignment (example)

ID# should be assigned before connecting the RS232C control cables and ID# must be cleared before they can be re-assigned.

5-1. Clearing I.D.

Press ADJUST to enter Adjust Mode and then press ID.ALL to enter I.D. Mode, press ID.SEL 3 times and then press ID.CLR to erase the current I.D.

5-2. Setting I.D.

Press ID.ALL so that ‘INPUT ID NUMBER’ appears and enter the desired 2 digit I.D. using the alpha-numeric keys. Press ID.SEL 3 times and then ID.SET , to assign the I.D. – the OSD will disappear and the unit will return to Normal Mode.

5-3 Selecting I.D.

If using Cube Commander software simply select the two digit I.D. for the cube you wish to control.

If using remote control it is necessary to press ID.SEL to access the correct menu for I.D. selection and control.

If ID.ALL is pressed instead of an alpha-numeric key ‘X’ will appear, pressing ID.ALL twice will display ‘XX’ which will allow control of all units simultaneously.

6. Magnification

To magnify the image repeatedly press MAG in Adjust Mode to change the magnification factor 1x1, 2x2, 3x3… It is also possible to select the magnification factor using the numeric keys so that magnifications such as 1x2, 2x3, 4x3 etc can be selected.

Once the desired magnification has been selected press LAYOUT followed by ٨٧<> to select the portion of the image to be displayed.

29

Page 29 Page 31
Image 30
Page 29 Page 31
Contents P600DL Safety Precaution Contents Safety Precautions for User For use of the equipment For servicing, maintenance and inspection Safety Precautions for User Precautions for USE and Maintenance Request to UserGeneral Descriptions Features Dimensions Function of I/O Panel BNCFunction of Power Panel Power Switch and Power IndicatorON/OFF Specifications Acceptable Signal Type Acceptable RGB Input Signal Timing Horizontal Timing Vertical TimingUnit-4Unit-3 Connection AT a Multi Projection SystemDisassembly HOW to Replace the LampDiassembly Power Supply Module Ballast Module Control Module ．LOCATION of KEY Components and Function ModuleExploded View of the Projection Block 96pin connector ．EXPLODED View of the Screen Block and Cabinet ．WIRING Adjustment ．ENGINE Mount Adjustment Adjustment Adjustment Adjustment Colour , Tint Multiple Screen Wall system example Electronic Circuit Explanation Electric Circuit Explanation Stanby Power FAN LampPower on FAN StopAppendix-2 Cont VN2 ID.CLR DMD Driver Board Debug Page Debugging Flow Diagram DMD Driver BoardBad image- Horizontal bands or lines Image shifted to left Parts List Location No Description 94800807 Ballast Module Assy 100W
Top Page Image Contents