Sherwood VR-654BD manual ReMote contRoL oPeRAtIon RAnGe, LoADInG BAtteRIes

VR-654(G)_ENG_100129_VR-654(G) 2010-01-29 오전 10:45 페이지 13

oPeRAtInG coMPonents WItH ReMote contRoL

1. Enter the setup code for each component other

than this unit you wish to control. (For details, refer to "ENTERING A SETUP CONE" on page 12.)

2. Turn on the component you want to operate.

3. Press the DEVICE button on the remote control

corresponding to the component you wish to operate.

Example) When selecting “MAIN” to operate this unit.

4. Aim the remote control at the REMOTE

SENSOR of the component you wish to control and press the button corresponding to the operation you want.

ReMote contRoL oPeRAtIon RAnGe

•Use the remote control within a range of about 7 meters (23 feet) and angles of up to 30 degrees aiming at the remote sensor.

7

■Note :

•Remote operation may become unreliable if the remote sensor is exposed to strong light such as direct sunlight or inverted fluorescent.

ENGLISH

LoADInG BAtteRIes

•When the remote control does not operate, the old batteries should be replaced. In this case, load new batteries within several minutes after removing old batteries.

•If the batteries are removed or have been exhausted for a longer period of time, memorized contents will be cleared. Should this happen, you should memorize them again.

1. Remove the cover.	2. Load two batteries ("AAA" size, 1.5V) matching
		the polarity.

• Remove the batteries when they are not used for a long time.

• Do not use the rechargeable batteries (Ni-Cd type).

• Be sure to use alkaline batteries.

13