Sherwood VR-654BD Leave a space around the unit for sufficient ventilation, Moisture condensation

Page 3

VR-654(G)_ENG_100129_VR-654(G) 2010-01-29 오전 10:45 페이지 3

Information for Users on Collection and Disposal of Old Equipment and used Batteries

These symbols on the products, packaging, and/or accompanying documents mean that used electrical and electronic products and batteries should not be mixed with general household waste. For proper treatment, recovery and recycling of old products and used batteries, please take them to applicable collection points, in accordance with your national legislation.

By disposing of these products and batteries correctly, you will help to save valuable resources and prevent any potential negative effects on human health and the environment which could otherwise arise from inappropriate waste handling.

For more information about collection and recycling of old products and batteries, please contact your local municipality, your waste disposal service or the point of sale where you purchased the items.

[Information on Disposal in other Countries outside the European Union]

These symbols are only valid in the European Union. If you wish to discard these items, please contact your local authorities or dealer and ask for the correct method of disposal.

Note for the battery symbol (bottom two symbol examples):

The sign Pb below the symbol for batteries indicates that this batteries contains lead.

CAUTION

• Leave a space around the unit for sufficient ventilation.

• Avoid installation in extremely hot or cold locations, or in an area that is exposed to direct sunlight or heating equipment.

• Keep the unit free from moisture, water, and dust.

• Do not let foreign objects in the unit.

• The ventilation should not be impeded by covering the ventilation openings with items, such as newspapers, table-cloths, curtains, etc.

• No naked flame sources, such as lighted candles, should be placed on the unit.

• Please be care the environmental aspects of battery disposal.

• The unit shall not be exposed to dripping or splashing for use.

• No objects filled with liquids, such as vases, shall be placed on the unit.

• Do not let insecticides, benzene, and thinner come in contact with the set.

• Never disassemble or modify the unit in any way. Notes on the AC power cord and the wall outlet.

The unit is not disconnected from the AC power source(mains) as long as it is connected to the wall outlet, even if the unit has been turned off.

To completely disconnect this product from the mains, disconnect the plug from the wall socket outlet.

When setting up this product, make sure that the AC outlet you are using is easily accessible.

Disconnect the plug from the wall outlet when not using the unit for long periods of time.

ENGLISH

PRECAUTIONS

moisture condensation

Moisture may form on the lens in the following conditions.

Immediately after a heater has been turned on.

In a steamy or very humid room.

When this unit is moved from a cold place to a warm one.

If moisture forms inside this unit, it may not operate properly.

In this case, turn on the power and wait about one hour for the moisture to evaporate.

If there is noise interference on the TV while a broadcast is being received.

Depending on the reception condition of the TV, interference may appear on the TV screen while you are watching a TV broadcast and this unit is left on. This is not a malfunction of this unit or the TV. To watch a TV broadcast, turn off this unit.

Do not transport this unit with discs left in it.

Do not place on the component that generates heat.

If so, the temperature inside this unit rises and malfunction may occur.

3

Image 3
Contents VR-654BD PAN-EUROPEAN Unified Voltage IntroductionMoisture condensation Leave a space around the unit for sufficient ventilationContents System Connections Connecting AUDIO/VIDEO COmPONENTSVideo output resolution Copyright protection systemHdmi OUT Connecting Digital INs Connecting SPEAkERSConnecting speaker wire Speaker placement Connecting PREOUTsConnecting to NETWORk Connecting for SYSTEm ControlFluorescent Display PLAY/PAUSE Front Panel ControlsRemote Sensor OPEN/CLOSEUniversal Remote Controls Repeat the above steps 1 to 4 for each of your components EnteRInG a setUP coDeFunction Table of the Numbered Buttons Enter a 3 digit codeLoADInG BAtteRIes ReMote contRoL oPeRAtIon RAnGeWhen SAT, TV, AUx is selected as an input source Basic OperationListening to a PROGRAm Source Adjusting the brightness of the fluorescent display Operating the sleep timerSurround modes SURRoUnD soUnDDrama When selecting an input source other than BD/DVDWhen selecting the BD/DVD MovieSelect the desired menu using the Cursor UP/DOWN buttons SYSTEm SetupSetting the sound parameter Turn the setup menu onWhen selecting the LFE LFE level When selecting the L.SYNC Lip-SyncWhen selecting the D.m. Dual mono When selecting the DRC Dynamic Range ControlSetting the speaker setup About the speaker size When selecting the SPEAkER ConfigurationPress the OK button to confirm your selection To cancel the test tone function, press the Return buttonWhen selecting the Crossover Frequency When selecting the Channel LevelAbout the speaker distance Setting the Tone①. Press the OK button to enter the tone adjustment mode When selecting the SPEAkER DistanceColor system format PReLIMInARY KnoWLeDGe ABoUt DIscs Playable disc typesRegion code Unplayable discsSYMBoL ABoUt InVALID oPeRAtIon PLAYABLe FILesCARe AnD HAnDLInG oF DIscs Avchd Advanced Video Codec High Definition DeFInItIon oF teRMsJpeg Joint Photographic Experts Group Before starting playback Case of use of the NUmERIC buttons on the remote controlPLAYInG a DIsc To start playback from the menuFrame advance playback To stop playbackTo pause playback Slow playbackPress the OK button Displaying disc informationPlaying the desired section of disc During playback, press the GO to buttonPlaying in random order Operations using disc menu, top menu, and Pop-up menuPlaying repeatedly Playing a specific section repeatedlyPress the Popup button to exit Switching the audio soundtrackDuring playback, press the Popup Menu button During playback, press the Audio buttonSwitching the subtitles Switching the camera anglesDuring playback, press the Subtitle button Press the Cursor Right button to enter the PIP mode menu Playing secondary videoPicture in PictureVirtual Package When selecting the Play File When selecting the Playlist Optical Disc or the USBWhen selecting the Remove from Playlist When selecting the Add To PlaylistTo specify the time interval Selecting an item in the play menuWhen entering file number Displaying file informationPlaying the desired section of file To change the effect on displaying pictures When clearing the number enteredWhen selecting the Slide Show Effects When selecting the Slide Show DelayTo control the music files During playback of music files, press the OK buttonOSD Menu Settings SettInG tHe sYsteM SettInG tHe DIsPLAY SettInG tHe LAnGUAGe SettInG tHe AUDIoParental Password Cancel SettInG tHe PARentAL contRoLWhen selecting the Parental Control or the Parental Level When selecting the Parental PasswordWhen selecting the manual SettInG tHe netWoRKWhen selecting the Wired IP SettingsWhen selecting the Network Test When selecting the manual or the DynamicWhen selecting the Off Select the desired FM mode Auto tuningManual tuning Auto presettingMEmORY BACkUP Function Presetting radio stationsTuning to preset stations TuningDisplaying RDS information FM mode, press the Search Mode buttonListening to RDS BROADCASTSFm only Searching for stations by program typeREmEDY Troubleshooting GuideREmOTE Control Unit PROBLEm MAIN Unit AmPLIFIER Section PROBLEmBD Player Section Specifications Fm Tuner Section DBf70 / 65 dB Setup Code Table Oceanic Inno HITNordmende InterfunkSanyo SambersSampo SamsungCity COM ArconAstra CH.MASTERPreamble GNU General Public LicenseEnglish No Warranty How to Apply These Terms to Your New Programs VR-654BD